UltraViolet Devices Altru-V Ultravoilet Lamp System Brochure & Specs

REPRESENTED BY:
UVC Fixturing – Fixturing consists of a UL Listed and labeled for use in air-streams
lamp, lamp clasps, UVC resistant wiring of 55–135°F. They are capable of pro-
harness, power supply and power supply ducing the specified output and organism
housing. destruction as listed under Irradiation and
Intensity above at no more than 13 Watts
Lamps – Each lamp contains no more
of power consumption for each square foot
than 5 milligrams of mercury. Lamp life
of treated, cross sectional area.
is 9000 hours with no more than a 20%
output loss at the end of the lamps life. Installation – Fixturing are electrically
Lamps are constructed with UVC resistant terminated to within factory supplied ballast
bases and do not produce ozone. When housings to meet NEC and local codes.
used for surface irradiation, the lamp Lamps should be mounted to irradiate the
selected will be equal to or no less than intended surface(s) as well as all of the
90% of the coil width. available line of sight airstream by proper
placement and incident angle reflection.
Irradiation – Fixtureless lamps are to be
installed in sufficient quantity and in such Safety – To protect maintenance
a manner as to provide an equal distribu- personnel, all access panels and doors
tion of UVC energy. When installed, the to the UVC assembly and/or within view
UVC energy produced will be of the lowest of the UVC assembly must include mechan-
possible reflected and shadowed losses. ical interlock switche(s) to insure that the
Note: the applied energy and its distribu- UVC assembly will be de-energized when
tion shall be verifiable using third any of these accesses are opened.
party algorithms.
Intensity – The minimal UVC energy
striking a surface is sufficient to continu-
ously destroy a monolayer of mold and
bacteria in less than six hours when at
55–135°F. The third party modeling shall
be available to determine the destruction
time for at least four of the most common
fan coil surface microbes.
Lamp Clasp – Lamp Clasps may be
permanently or magnetically affixed to the
irradiated cavity. They are constructed of
high memory, plated steel for maximum
holding power and corrosion resistance.
Lamp Wire – Is of sufficient length to
facilitate lamp connection to a remotely
located ballast. It includes a grommet to
facilitate safe passage through sheet metal
and into the ballast housing. Lamps are
capable of being mounted anywhere in the
Model No. Description
system and/or as shown on the plans.
VRSUS 12 V-Ray UVC Fixture
Power Supply – Power supplies are of
VRSUS 21 V-Ray UVC Fixture
the high efficiency electronic type, matched
VRSUS 33 V-Ray UVC Fixture
to the lamp and designed to optimize UVC
VRSUS 61 V-Ray UVC Fixture
photon production and reliability. They are VR MC V-Ray UVMagClasp (Pair)
* The V-Ray 12" and 64" units are non-inventory items subject to varying lead times.
Hg-LAMP CONTAINS MERCURY. Manage in Accord with
Disposal Laws. See: www.lamprecycle.org or call 877-PUREUVC
Specifications subject to change without notice.
Copyright 2004 UVDI. ALTRU-V and V-Ray SUS are trademarks owned by UVDI. Patent Pending. 23-1004 Rev A
ALTRU-V (A Division of UVDI)
26145 Technology Drive
Valencia, CA 91355
Tel 877-PUREUVC (877-787-3882)
Tel 661-295-8140
Fax 661-257-4698
www.altruv.com
1
2
1. V-Ray Bulb Lengths: 61"*, 36", 24" and 12"*.
2. V-Ray Magnetic Clip
Lamp Dim. Electrical Weight P/N
12" * 100–277Vac, 50-60 Hz, 11 Watts 3 lbs. 23-1012
21" 100–277Vac, 50-60 Hz, 15 Watts 3 lbs. 23-1021
33" 100–277Vac, 50-60 Hz, 21 Watts 3 lbs. 23-1033
61" * 100–277Vac, 50-60 Hz, 31 Watts 5 lbs. 23-1061
— — 0.5 lbs. 23-1063
V-RAY™ SUS V-RAY SUS
Easily Installed into hard to access systems delivering continuous
irradiation for improved heat exchange efficiency while reducing
foul odor, drain pain overflows and expensive coil cleanings!
vb:
uv_>
• 4-lamp sizes (12", 21", 33" and 61")
• Lowest mercury content available
• UV output regulated to keep levels
within ACGIH and NIOSH exposure
guidelines (patent pending) thus
– Extending lamp life and
– Ensuring safe exposure limits for
room occupants or materials
• UL recognized components, ETL Listed
• Ideal for any vertical or horizontal
system
• Ease of installation – Simple Lamp
Clasps (magnetic Lamp Clasp optional)
• Single point electrical connection
• UVC resistant materials
• Screw terminals for easy field wiring
• Remotely located power source
offering ease of installation and
mounting options
All ALTRU-V products are designed to transform HVAC efficiency, maintenance
• Restores air handling unit to near
optimal operating capacities
and longevity. By applying real science, the relentless cleaning power of UV and
• Can lower energy costs for restored
systems
the most affordable products by UVDI, optimal HVAC maintenance solutions can
• Reduces costly maintenance and
replace outdated mechanical and chemical cleanings that can be both costly and
cleaning programs
• Eliminates foul system odors (dirty
dangerous and shorten equipment life. The results are lower operating costs,
sock syndrome)
safer environments for maintenance personnel and occupants, as well as
• Has one of the lowest ownership
costs in the industry
documented cleaner air.
• Improves indoor air quality by
destroying system microbes
ALTRU-V's V-Ray™ provides unique electronically controlled energy output (patent
• Will not harm building occupants,
pending) at registers and grills to meet acceptable levels as recommended by the
equipment or furnishings
• One-year warranty on both the fixture
National Institute for Occupational Safety and Health (NIOSH) and the American
and the lamp
Conference of Governmental Industrial Hygienists (ACGIH), yet it delivers the
proper amount of energy necessary to control the growth of micro-organisms such
as mold and bacteria.
V-Ray SUS: 12", 21", 33", 61" Lamp Sizes.