Vectronics PM-30 SWR Owner's Manual

PM-30 SWR/Power Meter
PM-30 SWR/Power Meter
INTRODUCTION
The PM-30 can simultaneously measure and display forward
power, reflected power, and SWR in the frequency range of 1.8 to
60 MHz. Accuracy of the readings is assured because the PM-30
features a true shielded directional coupler. The back lit meter
can also display either peak or average power readings.
SPECIFICATIONS
FREQUENCY RANGE: ...............................1.8 to 60 MHz
POWER RANGE: .........................................300 and 3000 W
Ranges
METER LAMP: ............................................12 Vdc with on/off
switch
OPTIONAL ADAPTER:...............................Vectronics AC-12
DIMENSIONS: .............................................5.3"W x 5.75"D x
3.5"H
WEIGHT: ......................................................1.2 lbs.
CHASSIS:......................................................Alodine
Aluminum
FRONT PANEL CONTROLS
ON/OFF.........................................................Meter Lamp Switch
3000W/300W ................................................Range Switch
PEAK/AVG...................................................Selection Switch
REAR PANEL CONNECTIONS
RF OUTPUT .................................................SO-239 Connector
RF INPUT .....................................................SO-239 Connector
POWER CONNECTOR................................2.5mm coaxial type
jack
Owner's Manual
Plated
1
PM-30 SWR/Power Meter
INSTALLATION
1. Connect the coax connector labeled RF INPUT to the
transmitter using PL-259 connectors.
tuner, the PM-30 should be placed between the transmitter and
antenna tuner.
2. Connect the coax connector labeled RF OUTPUT to the
antenna using a PL-259 connector. If using an antenna tuner,
the RF OUTPUT is connected to the antenna tuner input.
Note: Vectronics recommends using high quality coax cable
for all coax connections.
3. If a lighted meter is desired, a 9-12Vdc power supply, such as
the AC-12, must be connected to the power jack on the back of
the unit. This is a 2.5mm coaxial type jack with the center
positive.
OPERATION
1. Set the desired power range by using the push-button switch on
the front panel labeled POWER 3000W/300W. With the
switch in the out position, the 300W range is selected. When
the switch is locked in, the 3000W range is selected.
2. The Peak Reading feature may be switch on/off by using the
push-button switch labeled POWER PEAK/AVG.
reading is activated when the switch is locked in.
3. SWR is indicated at the intersection of the two meter pointers.
While transmitting, read the SWR from the red SWR line
nearest the intersecting point.
2
Owner's Manual
If using an antenna
Peak