Remove rings, wristwatch and articles of clothing batteries must be disposed of the usage of other than by EnerSys/GAZ specified parts, Then seek medic with metal parts that may come into contact with the battery terminals.
If visual inspection is not possible, due to restricted view, use charge controller to maintain the battery in propper conditions. an electrolyte level testing tube to check the electrolyte level. For further instructions, please contact your GAZ/EnerSys There are two methods of charging established in the market for representative.
Page 4
Check that all connectors, nuts and screws are correctly torqued. All metal parts of the battery should be coated with a thin layer of anti-corrosion grease supplied by GAZ. Do not coat any plastic parts of the battery, for example cell cases.
Page 5
7. Removal of the Transportation Plugs and Fitting of Vent Caps SOL 140-485 G SOL 555-1680 G Step 1 Step 1 Step 2 Step 2 (before commissioning charge) Step 3 (before commissioning charge)
Page 6
8. Layout details: inter-cell connection SOL 140-485 G 1 Cell 2 Cell connector 3 Spring washer 4 Screw 5 Connector cover SOL 555-1680 G 1 Cell 2 Cell connector 3 Terminal connector Innengewinde / Female thread 1 Zellengefäß / Cell case 4 Spring washer 2 Zellenverbinder / Cell connector 5 Screw...
Page 7
9. Cell Layout SOL 140 G - SOL 310 G SOL 345 G - SOL 485 G (Female thread M8) (Female thread M10) KGL 1260 P - KGL 1570 P (Female thread M10) SOL 555 G - SOL 693 G SOL 730 G - SOL 935 G SOL 1110 G - SOL 1525 G SOL 1680 G...
Page 8
Tel.: +49 375 86 0 Mob.: +49 173 95 117 93, +420 602 174 634 Fax: +49 375 86 440 e-mail: david.vodicka@gaz-gmbh.com, david.jez@gaz-gmbh.com sales@gaz-gmbh.com www.gaz-gmbh.com All dimensions and weights stated are subject to usual manufacturing tolerances, electrical values are approximate. The right is reserved to make any...
This manual is also suitable for:
Sol 140 gSol 310 gSol 345 gSol 485 gSol 555 gSol 693 g...
Show all