Yin Yan Model Tech EMAX Series User Instruction

E
MAX
User Instruction for R/C Model Car ESC
Continuous
Item
EMAX-6A
EMAX -10A
EMAX -30A
EMAX -45A
EMAX -60A
EMAX -80A
EMAX -120A
EMAX -150A
EMAX -120A-HV
Full protection features including low voltage, over-heat, throttle signal loss, startup protection and self-check.
Compatible with sensor-free brushless motors.
Excellent startup performance, great throttle linear and quick throttle response.
Support highest motor speed 240,000RPM (2 poles), 80,000RPM (6 poles) and 40,000RPM (12 poles).
The parameters of ESC can be configured via pressing the keys.
System can automatically detect throttle neutral point and neutral range is adjustable.
Three working modes can meet different requirements.
4 steps of maximum reverse force adjustment, 5 steps of maximum start force adjustment.
3 steps of maximum brake force adjustment, 5 steps of drag brake force adjustment, 4 steps of initial brake force adjustment.
Support 1 cell operation (min voltage: 3V, only available for EMAX-6A and EMAX-10A).
Note: For EMAX-150A and EMAX-120A-HV, an UBEC or individual battery pack is required to power the receiver and
servos, and the red line (+5V) in 3 pin must be pulled out!
Normal Startup Procedure
Move throttle stick to the neutral position → Switch on the transmitter →Connect battery pack to ESC → System detects the
neutral throttle signal, makes a long "beep-" sound → System detects battery voltage and makes several short "beep-" sounds,
which denotes the number of battery cells → when self-test is finished → "♪ 1 2 3" tone should be emitted →ready for start.
Setting Throttle Range (Throttle range should be setup when a new transmitter is being used)
Switch off the ESC → Switch on the transmitter → Press and hold the " SET " key → Switch on the ESC → Push the
throttle stick to the top point of forward within two seconds → wait for one second → System detects the Max throttle signal, and
makes two "beep-" sounds, which denotes that Max throttle has been confirmed and saved → Pull the throttle stick to the top point
of backward →System detects the Min throttle signal, makes two "beep-" sounds, which denotes that Min throttle has been
Specification
Battery Cell
current
Li-XX Ni-Mh /Ni-Cd
6A 1-2
10A 1-2
30A 2-3
45A 2-3
60A 2-4
80A 2-4
120A 2-4
150A 2-6
120A 2-10
Dimension
Weight（g）
(mm)
L×W×H
3-8 12 x 20 x 5
3-8 22 x 17 x 7
4-9 45x32x20
4-12 45x32x20
4-15 47x41x29
4-15 47x41x29
4-15 47x41x29
5-18 96x55x21
5-30 96x55x21
Features
Instructions
1
YIN YAN MODEL TECH.MFT.
BEC
4 1A/5V
8 1A/5V
50 2A/5V
50 2A/5V
80 2A/5V
80 2A/5V
80 2A/5V
180 0.2A/5V
180 0.2A/5V
Program
By
key
NO
NO
Yes
Yes
Yes
Yes
Yes
NO
NO