North American Signal LED Traffic Assist III Series Installation And Operating Instructions

1. The package should contain the following:
a. LED Traffic Assist
taped to end of cable;
b. Control Head with 8 inches of cable;
c. 2, 3, or 4 - "L" brackets (depending on model) for optional mounting
d. Instruction sheet.
2. Attach the LED Traffic Assist Control Head to the dash using the bolts provided.
Connect the red/black duplex wire to power (fused for a minimum of 5 Amps) and to
a ground.
3. Install the LED Traffic Assist bar horizontally, with the curved side up (product label
facing up and cable exiting the passenger side of the vehicle when installed in the rear
of the vehicle), in one of the following two ways:
a. Attach to any vertical surface using the 5/16-18 x
bolts coming out the rear of the bar; or
b. Mount the two "L" brackets on a horizontal surface, and attach the Traffic Assist
bar to the "L" brackets.
4. NOTE: For TA18LS versions, 10' of interconnect cable connects the two 4-segment
heads, each half is clearly marked as "LEFT" & "RIGHT" sides. When positioned
correctly the power cable runs up the passenger side of the vehicle for rear mount.
Unit comes pre-assembled unless otherwise noted.
5. Run the 12 conductor cable from the LED Traffic Assist
sure to leave the connector off until cable is completely installed in the vehicle.
6. Plug the individual wire pins into the 12 pin connector taped to the end of the cable
according to the color coded diagram shown below and also the diagram shown on
the back of the LED Traffic Assist Control Head.
# COLOR
4 PINK
8 TAN
12 YELLOW
LED Traffic Assist
Installation and operating instructions for:
TA18LS-A, TA18LS-A1, TA36L-A, TA36L-A1, TA36L-A2
TA42L-A, TA42L-A1, TA52L-A, TA52L-A1, TA52L-A2*
TM III light bar with 25 feet of cable and 12 pin connector
# COLOR
3 RED
7 WHITE
11 ORANGE
III (12/24VDC)
TM
inch long stainless steel hex
to the control head. Be
TM
# COLOR
2 BROWN
6 GREEN
10 GRAY
# COLOR
1 BLACK
5 VIOLET
9 BLUE