Advertisement
Quick Links
Wireless Key Pad with Receiver – Wiring Guide for Q60AR / Q71A, Q71B
STEP 1 – Remove PCB Casing
STEP 2 – Wire to Control Board
Single screw holds the internal PCB holder to the
outer casing. Remove this screw and pull down the
bottom section
This will expose the terminals and the push buttons
for synchronising with wireless keypad.
With the two halves now
separated, terminals numbered 1 to
6 are seen.
Using CAT5 cable / alarm cable /
bell wire, insert cabling as follows:
Advertisement
Summary of Contents for Gate Motors Q60AR
- Page 1 Wireless Key Pad with Receiver – Wiring Guide for Q60AR / Q71A, Q71B STEP 1 – Remove PCB Casing Single screw holds the internal PCB holder to the outer casing. Remove this screw and pull down the bottom section This will expose the terminals and the push buttons for synchronising with wireless keypad.
- Page 2 STEP 3 – Program Keypad to Receiver Before replacing PCB holder into it’s frame to be finally secured, we need to synchronise the keypad with the receiver. This is a two stage process: Stage 1 – On the keypad, Press and HOLD the “ON” button for 5 seconds, the red LED light will come on.