WAC Lighting Volta R4RD1T Installation Instruction

INSTALLATION INSTRUCTION
Volta 4.5" LED - Downlight Round Trim
R4RD1T, R4RD2T, R4RD1L, R4RD2L
SAFETY INSTRUCTION
IMPORTANT: NEVER attempt any work without shutting off the electricity.
• Read all instructions before installing.
• System is intended for installation by a qualified electrician in accordance with the National Electrical Code and local regulations.
• Go to the main fuse box, or circuit breaker. Place the main power switch in the "OFF" position and unscrew the fuse(s) or switch "OFF" the
circuit breaker switch(es) that control the power to the fixture or room that you are working on.
• Place the wall switch in the "OFF" position.
AVERTISSEMENT
IMPORTANT : Coupez l'électricité avant TOUTE manipulation.
• Lisez toutes les instructions avant d'installer.
• Système est destiné à être installé par un électricien qualifié en conformité avec le code national de l'électricité et les règlements locaux.
• Accédez au panneau central de disjoncteurs ou de fusibles de votre demeure et placez l'interrupteur principal en position d'arrêt (« OFF »).
• Placez l'interrupteur mural en position d'arrêt (« OFF »).
CAUTION
All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts, or use any parts that are worn out or broken.
Failure to follow could invalidate the ETL/cETL listing of this fixture.
TRIM MODEL
The trim R4RD1T and R4RD2T can be used with remodel and new construction round housings. The invisible trim R4RD1L and R4RD2L to be
used with new construction round housing. Refer to specification sheets for compatible housing and trim details. Follow appropriate housing
instructions to begin installation.
TRIM INSTALLATION (R4RD1T, R4RD2T)
Remove trim from trim assembly (See FIG.1)
1.
2. Raise trim assembly to ceiling cutout and connect power connector and safety cable (See FIG.2)
3. Install connector cap onto top of trim assembly, careful not to pinch power wiring. Make sure the cap wire cable aligns with the notch on
the top of heat-sink. (See FIG.3).
FIG. 1
Trim
assembly
Trim
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. September, 2016
FIG. 2
Power
Connector
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
FIG. 3
Wire
Cable
Safety Cable
Notch
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Cap
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
1