CPI ACM-197 Quick Manual

C
DRILLING HOLE
INSTRUCTIONS FOR
WITHOUT PRE-DRILLED HOLE
STEP 1
Cut out template along dotted line.
7/8"
(2,223 cm)
5/8"
20mm
(1,588 cm)
hole
TEMPLATE
(This side up)
3-1/4" (8,255 cm)
STEP 3
Tape template
securly in place.
STEP 4
Making sure that 7/8"
(2,223 cm)
center point is aligned,
20mm hole
carefully drill hole using a
TEMPLATE
(This side up)
20 mm hole saw.
3-1/4" (8,255 cm)
By: Champlain Plastics Inc.
87 Pillsbury Road, Rouses Point, NY 12979
www.champlainplastics.com
INTO SKIMMER
STEP 2
Line template up with the top edge
of skimmer. The edge of the template MUST
be flush with the side edge of the skimmer.
7/8"
(2,223 cm)
Align template 20mm hole
with top edge
TEMPLATE
of skimmer.
(This side up)
3-1/4" (8,255 cm)
Template MUST
be flush with
edge of skimmer.
5/8"
(1,588 cm)
Remove template
and follow instructions
for installation
of skimmer light (A)
A
5/8"
(1,588 cm)
FOR INSTALLATION
ON SKIMMER
WITH
PRE-DRILLED HOLE
MAX
MIN
• Risk of electrical shock, if instructions are not followed. Connect only to a grounded GFCI outlet that is a
minimum of 10 feet (3 m) away from the pool. DO NOT USE EXTENSION CORDS.
• Do not let children use this device unsupervised.
• For use on permanent above-ground pools only.
• Do not use the light if the lens, transformer or cord is damaged.
WINTER STORAGE: Freezing weather may damage light fixture. Disconnect light and remove from the pool.
Store in dry space at room temperature.
NOTE: Operating and Pairing Remote with Pool Lights Instructions
By: Champlain Plastics Inc.
INS-197-rev4E 87 Pillsbury Road, Rouses Point, NY 12979
www.champlainplastics.com
09-2019
ACM-197, ACM-197C
Skimmer Cover Plate with Ultra Bright LED Light
TYPE OF INSTALLATION:
B
FOR INSTALLATION
WITHOUT
ON SKIMMER FOR
PRE-DRILLED HOLE INTO SKIMMER WITHOUT
PRE-DRILLED HOLE
20mm
MAX
MIN
WARNING
included with ACM-197C only.
C
INSTRUCTIONS
DRILLING HOLE
TOOLS NEEDED
INS-197-rev4E
09-2019