OFM Marque Series Assembly Instructions

Marque Reception Station
Parts Listing for
Single Section Station
A B
Transaction Top Work Surface Top
1 Unit 1 Unit
C D
Side Wall Curved Panel
2 Units 1 Unit
E F
Support Bar Short Safety Knob
1 Unit 7 Units
G H
Long Safety Knob Leveling Glide
2 Units 1 Unit
Assembly Instructions
Please read all instructions before beginning.
NO TOOLS REQUIRED TO ASSEMBLE SINGLE SECTION STATION. Two people are needed for assembly.
• If you purchased models 55290 or 55310 (1 section) follow steps 1-3.
• If you already have an existing Marque Reception Station and are adding sections to it, follow steps 4 - 8.
• If you purchased models 55292 or 55312 (2 sections), 55293 or 55313 (3 sections), 55294 or 55314 (4 sections),
55296 or 55316 (5 sections), follow steps 1A, 6, 7 & 8.
Step 1A:
Step 1B:
Step 2:
Step 3:
NOTE: Please see page 2 to continue assembly of Multi-Section Stations.
1A 1B
D
C
H
C
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this desk as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Insert Leveling Glide ( H ) into base of Curved Panel ( D ) if not already attached. Stand Curved Panel ( D ) up with
Leveling Glide on floor. While one person holds Curved Panel ( D ) , place one Side Wall ( C ) alongside Curved
Panel ( D ) as shown. Slide steel ears on the Curved Panel ( D ) into holes of vertical support beam attached to
Side Wall ( C ) and force downward to lock panel.
Attach other Side Wall ( C ) as explained above.
Place Work Surface Top ( B ) on top of horizontal support beams attached to the Side Walls ( C ) . Attach
Support Bar ( E ) from underneath by placing it diagonally from the front of one Side Wall ( C ) to the back of the
other and secure with two Long Safety Knobs ( G ) . Insert them through the Support Bar ( E ) and the horizontal
support beams of the Side Walls ( C ) then into the bottom of the Work Surface Top ( B ) . Use two Short Safety
Knobs ( F ) to finish attaching Work Surface Top ( B ) by inserting them through remaining holes in the horizontal
support beams of the Side Walls ( C ) and into the bottom of Work Surface Top ( B ) and tighten.
Place Transaction Top ( A ) on support brackets attached to the top of each Side Wall ( C ) and secure using
Short Safety Knobs ( F ) in all holes. Flip up center support tab on inside of Side Wall ( C ) and secure with
Short Safety Knob ( F ). You can now tighten all knobs securely.
2
G
F
F
E
06.29.2016
3
B
F
G
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
support@ofminc.com
page 1
A
• 919-362-4765 (fax)
• www.ofminc.com