Carlisle 2424CS07 Assembly Instructions

Assembly Instructions:
Checkout Shields
PRODUCT NUMBERS: 2424CS07, 3636CS07
Parts Included:
1 Acrylic Shield, 4 Screws, 4 Rubber Washers,
1 Roll Double-Sided Tape
INSTALLING WITH SCREWS:
Step 1 – Figure A
Remove white film from both sides of shield.
Step 2 – Figure B
Align Shield to desired height on counter.
Step 3 – Figure C
Pick first, second, third and fourth attachment
point and mark.
Step 4
Place Shield to the side.
Step 5 – Figure D
Make pilot holes using a 9/64" drill bit to each
attachment point; remove debris from hole.
Step 6 – Figure B
Hold Shield in place.
Step 7 – Figure E
Attach rubber washer to screw and drill first
screw into place.
Step 8 – Figure F
Using a level, make sure Shield is level.
Step 9 – Figures E & G
Attach rubber washers to second, third and
fourth screws and drill in place.
Step 10 – Figure H
Clean Shield. DO NOT use products with
ammonia or abrasive cleaners.
© 2020 Carlisle FoodService Products
Oklahoma City, OK 73131
www.carlislefsp.com | 800-654-8210
A
C
E
G
#104910034 4/2020
B
D
F
H
Continued