NICOR DCR56 Series Installation Instructions

WARNING:
•Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing.
•To prevent early lamp failure, lamp should only be installed in operating environments
between -20°C and + 40°C (-4°F and 104°F)
•No user serviceable parts inside. To avoid electric shock do not disassemble product.
•This product is not intended for use in emergency light fixtures or exit signs.
ATTENTION:
Turn power off before inspection, installation, or removal.
Suitable for use in wet locations.
Use only on 120VAC, 60Hz circuits.
What's In The Box
One (1) DCR
Installing the DCR
1 Carefully unpack the downlight from its packaging. Inspect product for defects due to shipping.
2 If using optional colored trim, align trim onto downlight and secure by bending over tabs.
3 Disconnect Edison base
from downlight and
screw into socket inside
recessed housing.
(GU24 base option available).
5
Squeeze torsion springs together and install into
torsion spring brackets inside recessed housing.
NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393
www.nicorlighting.com November 9, 2017 9:13 AM
One (1) Edison Adaptor
Make sure all power is turned off before beginning installation
DCR56 Recessed LED Downlight
INSTALLATION INSTRUCTIONS
Model:
DCR56108120, DCR56112120
Tools Needed
The DCR Recessed LED Downlight is designed to fit into
a 5" or 6" housing with torsion spring receiving brackets.
For use in a 5" or 6" housing simply compress the torsion
spring arms inward until torsion springs line-up with
mounting brackets. No tools are necessary for installation.
4
Plug the downlight connector into the Edison
(or GU24) base connector.
Carefully route wires into housing and push the
6
downlight upward, flush to ceiling surface.
Minimum Lamp
Compartment Dimensions
5.71"
145 mm
5.00"
127 mm