JJB Electronics Artist Series Installation Instructions

Artist Series - Prestige-110 installation instructions
Please note;
Although every system is tested before shipping, we recommend that you plug it into your amp and test it before installation. This can be
done by simply tapping on the transducers while plugged in. You should hear the tapping sounds through your amplifier.
Installation;
Tools you will need;
A drill
A 1/2 drill bit
Super glue gel
Installation of the endpin jack:
1.Drill or widen the endpin hole to 1/2" using protective tape to cover the area around the hole. This helps to prevent chips and
scratches.
2.Unscrew the endpin jack's strap mount knob
3.Remove the nut and washer.
4.Find out the thickness of your end block and set the nut on the cap accordingly. Once in place, screw the cap against it to
secure the nut.
5.Insert the jack from the inside into the endpin hole.
TIP: a chopstick or something similar helps to get a hold of the jack and pull it through the hole.
6.Attach outside washer and nut and tighten. Attach the end knob.
Transducer installation –
The piezo should be mounted as close as you can get it to being under the bridge. Once you determine where you would like to mount the
piezo, attach it to the inside of the guitar top by placing a thin layer of super-glue gel on the piezo and hold it in place for about 45 seconds.
The installation point that will result in the most amount of gain is directly under the saddle on the bridgeplate.
We cannot be responsible for guitar damage caused by installation.