Banner SureCross DX99 FlexPower Series Manual

SureCross DX99 FlexPower Node (Polycarbonate Housing)
Switch configurable Node with two discrete inputs and two analog inputs (powered by external battery module only)
For additional information, updated
documentation, and accessories, re-
fer to Banner Engineering's website,
www.bannerengineering.com/sure-
cross.
Model (0 to 20 mA)
DX99N9X2S2N0M2X0A2
DX99N2X2S2N0M2X0A2
DX99N9X2S2N0M2X0A1
DX99N2X2S2N0M2X0A1
Model (0 to 10V)
DX99N9X2S2N0V2X0A2
DX99N2X2S2N0V2X0A2
DX99N9X2S2N0V2X0A1
DX99N2X2S2N0V2X0A1
Internal antenna models are also available. For more information, contact your local Banner Engineering Corp. representative.
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to serious
injury or death. This device does not include the self-checking redundant circuitry necessary to allow its
use in personnel safety applications. A sensor failure or malfunction can cause either an energized or de-
energized sensor output condition.
P/N 142496 Rev. F
The SureCross® wireless system is a radio frequency network with integrated I/O that can oper-
ate in most environments and eliminate the need for wiring runs. DX99 wireless networks are
formed around a Gateway, which acts as the wireless network master device, and one or more
Intrinsically Safe Nodes.
• Wireless industrial I/O device with two selectable discrete inputs and two analog inputs
• FlexPower® power input requires power from the DX81H Battery Supply Module
• DIP switches for user configuration
• Frequency Hopping Spread Spectrum (FHSS) technology and Time Division Multiple Access
(TDMA) control architecture ensure reliable data delivery within the unlicensed Industrial, Sci-
entific, and Medical (ISM) band
• Transceivers provide bidirectional communication between the Gateway and Node, including
fully acknowledged data transmission
• Lost RF links are detected and relevant outputs set to user-defined conditions
• DX99 Polycarbonate housings are certified for use in Class I, Division 1, Groups A, B, C, D;
and Zone 0 (Category 1G) when properly installed in accordance with the National Electrical
Code, the Canadian Electrical Code, or applicable local codes/regulations
Frequency Boost Voltage
900 MHz ISM Band
18V
2.4 GHz ISM Band
900 MHz ISM Band
10V
2.4 GHz ISM Band
Frequency Boost Voltage
900 MHz ISM Band
18V
2.4 GHz ISM Band
900 MHz ISM Band
10V
2.4 GHz ISM Band
Inputs and Outputs
Discrete Mode
Inputs: Two selectable discrete
Switch Power: Two, Configurable
Inputs and Outputs
Discrete Mode
Inputs: Two selectable discrete
Switch Power: Two, Configurable
7/1/2013
Analog Mode
Inputs: Two selectable discrete, two
0 to 20 mA analog
Switch Power: One, Configurable
Analog Mode
Inputs: Two selectable discrete, two
0 to 10V analog
Switch Power: One, Configurable
0 142496 6