Page 1
User Manual Fast Ethernet Optical Switch (1 Fiber Port and 4 UTP Ports) Brief Introduction Many thanks for purchasing our fiber optic equipment, this fiber switch supports IEEE802.3U/100Base-Tx/Fx protocol, as well as 10/100M auto-negotiation full duplex and half duplex. The following purchasing guide...
Fiber Switch 1 piece AC/DC5V1A Adapter 1 piece Copy of user manual 1 piece Installation 1. Interface RJ-45 Interface RJ-45 Connector supports CAT5 twisted-pair with typical length of 100 meters. It features the function of MDI-MDIX through parallel lines. Fiber Interface SC/ST fiber interface is of 100M full-duplex mode,dual fiber(TX and RX)should be cross-connected(TX-RX,...
Page 4
The network device(work station,hub or switch) with RJ-45 interface is connected to RJ-45 jack of optical transceiver through twisted-pair,and multimode/single mode fiber is connected to SC/ST fiber interface of the optical transceiver.Then switch on, the corresponding LED is on for correct connection.(See the table below for the LED indicator lamp) Figure 1 Schematic drawing of connection Explanation for LED indicator lamp...
Page 5
Packet goes through TX end Link/Act Blink Power is on and normal Transmission Characteristic Optical Receiving wavelengt Distance Model Power Sensitivit (KM) (dBm) y (dBm) (nm) JF954MM-2 1310 -22~-12 ≤-30.0 ≥2 JF954SM-25 1310 -15~-8 ≤-38.0 ≥25 JF954SM-40 1310 -8~-3 ≤-38.0 ≥40 JF954SM-60 1310 -3~0 ≤-38.0...
4.Automatic identification of MDI/MDI-X cross line. 5.Support max forwarding package length 1552/1536 bytes option. 6.In conformity to safety code of FCC and 15 CLASS A and CE MARK. Technical Parameters Support IEEE 802.3z/AB 100Base-T/SX/LX/ZX 1.Connector: 4 UTP RJ45 connector, 1 SC/ST/FC connector.
This manual is also suitable for:
Jf954sm-25Jf954sm-40Jf954sm-60Jf954sm-80Jf954sm-100Jf954sm-120...
Show all