Summary of Contents for Lomart Deluxe Thru-Wall Skimmer 1-4113-006
- Page 1 The Single Source Supplier A Division of Hoffinger Industries, Inc. Deluxe Thru-Wall Skimmer Models 1-4113-006/1-4213-006/1-4313-006 Owner's Guide 365-1651...
- Page 2 24" of water Make sure skimmer is located in result. in your pool. (Refer to Lomart Pool an area of the pool that allows: Installation and Assembly instructions.) 1. easy access for service and maintenance.
- Page 3 CAUTION Always keep face plate mounting screws and return fitting tight. Failure to do so could cause leakage. Refer to CAUTIONS. From inside of pool, install the Fig. 6 skimmer face plate and other gasket by aligning to skimmer body. Secure Assemble cover plate to skimmer by lightly engaging all 15 #12 x 27/32 Fig.
- Page 4 Fig. 9 Fig. 15 Fig. 12 From inside the pool, place a board Hold eyeball inside return fitting Hold the return fitting body so the against the liner and hold it firmly adaptor with eyeball insert toward hose fitting end is pointing straight against the return fitting cutout in the inside.
- Page 5 2. Stop pump. 10. Your vacuum head should now be drawing water and ready for 3. Clean strainer basket. (Refer to use. If vacuum does not pickup, Fig. 19). check the following: A. Filter is dirty. Backwash filter. B. Debris is clogging vacuum head or hose, skimmer or pump strainer basket.
-
Page 6: Exploded Parts
EXPLODED PARTS MODELS 1-4113-006, 1-4213-006, 1-4313-006 MODEL 1-4113-006 (GRAY) PARTS LIST ITEM DESCRIPTION 308-1089 Deluxe Skimmer Gasket 330-1004 #12 x 27/32 Phillips Screw 330-1008 #8 x 1/2 Phillips Screw 330-1054 #13-16 x 5/8" Slotted Screw 340-1589 Skimmer Face Plate 1121-1467 Skimmer Lid w/Decal 340-1321 Cover Plate... - Page 7 MODEL 1-4213-006 (ALMOND) PARTS LIST ITEM DESCRIPTION 308-1089 Deluxe Skimmer Gasket 330-1004 #12 x 27/32 Phillips Screw 330-1008 #8 x 1/2 Phillips Screw 330-1054 #13-16 x 5/8" Slotted Screw 340-2087 Skimmer Face Plate 1121-1468 Skimmer Lid w/Decal 340-1321 Cover Plate 340-1253 Hose Adaptor 1121-1461...
- Page 8 Do not remove or cover. Change of Design: Lomart Industries expressly reserves the right to change or modify the design and construction of any product in due course of our manufacturing procedures, without incurring any obligation or liability to furnish or install such changes or modifications on products previously or subsequently sold.