iHold Music 2LA Quick Start Manual

►Plug the included AC adapter (110- 240 V AC to 5V DC)
Confirm that White LED lights in front of unit are double blinking
►Use one of your telephones and unplug the cord for L1/L2 from it and connect it to L1/L2 IN jack on iHOLD device
now connect theL1/L2 OUT jack to your telephone using the provided cord, check for dial tone on lines 1 & 2
►If applicable unplug the cord for L3/L4 from telephone and connect it to L3/L4 IN jack on iHold device , now connect
the L3/L4 OUT jack to your telephone using the provided cord, check for dial tone on lines 3 & 4
► Wait till LED lights turn OFF - observe that after you connect the lines the blinking lights 1
seconds
(on non existing lines the lights keep blinking and that is OK)
Please note: just
one telephone
may be
connected to this
device, other
telephones
remain
connected to
their own wall
jacks and they
all work.
•
Now connect the Audio Input to a source for audio such as a digital player, Radio, CD Player, PC
Switch set to 1: Hold button activation
Use this setting when all phones are corded ( not cordless type like corded base station + portables) and all are same model
(for example all are ATT 993)
Operation: make or receive a real call, the LED on the iHOLD turns ON solid, then simply press the
telephone, the Music will be heard to the caller and the LED on the iHOLD device starts to BLINK , to return to the call just re-
select that line. (Be sure to allow 1 or 2 seconds before putting a call on HOLD).
The 1 st time your are setting the device If it did not work hang up and try it again 2 or 3 times.
If music on hold does not work in this setting
Switch set to 2: Flash activation
This setting utilizes Flash then Hold activation method, this setting supports any phone or any mix of brands with instant
activation by pressing Flash then Hold
Operation: make or receive a real call, the LED on the iHOLD turns ON solid, then simply press the
HOLD
button on your telephone, the Music will be heard to the caller and the LED on the iHOLD device starts to BLINK , to
return to the call just re-select that line and speak into the audio to stop it for example say : "Hi I am Back" (Be sure the call
has been on Hold at least 4 seconds before you try to voice deactivate the audio)
You may also re-select the line that has been on Hold and press
If for some reason you are not able to voice -deactivate, try speaking a little louder or more direct into the microphone, if that
does not work hang up and set the switch to 3. Remember you can always use the Flash button to deactivate the audio as well.
The FLASH button could be labeled as Call Wait or LINK or ON or TALK button on some telephones
Hold 2LA, Hold 4LA
i i
Advanced Music On Hold Adapter
Rev 36
110 - 240 V
Not used
Not used
A B C 1 2 3
L1 L2
1 2 3
C
(for example ATT 1040,1070,1080)
1 2 3
C
Be sure not to use a different power adapter or the unit will be damaged
Audio
MOH
player,
Radio, CD
player
L3/L4
OUT
AUDIO INPUT
Not used
, hang up and change switch to setting 2 or 3
to stop the audio
FLASH
1
st stops then turns OFF after 20
L1/L2 L1/L2
L3/L4
OUT IN
IN
L3 L4
button on your
HOLD
then
FLASH
Back
View
Front
View