Advertisement
Quick Links
3
Winch Strap
11136, 11137, 11138 cut-end
11141, 11147, 11153 loop-end
11133, 11135, 11131 tail-end
11140 (PWC loop-end)
11129 (PWC tail-end)
Installation Instructions
Form Number 19690R Rev. A
Attwood marine hardware, navigational lighting, bilge pumps, and
other marine accessories are specified more than any other brand by
America's best-known boat manufacturers as original equipment.
Look to Attwood for quality replacement parts and marine accessories.
SAVE THESE INSTRUCTIONS
Rating
FOR WINCHES RATED UP TO 2,000 POUNDS MAXIMUM. These
winch straps can be used on winches rated up to 2,000 pounds. In
order to maintain the proper rating for the trailer winch, DO NOT
install these straps on winches rated above 2,000 pounds.
CAUTION:
Winch straps are used to launch and retrieve boats to and from
trailers only. Never have less than four full wraps of the strap around
the winch drum when launching or retrieving the boat. Never use
winch or winch strap for any other purpose than those for which they
were designed. Failure to do so may result in product damage or
personal injury.
Before each use, check the strap for proper retention in the winch
and for any signs of fraying. Make sure there are no sharp edges in
contact with the winch strap. Be sure the hook is in proper working
order and the stitching is not unraveled. Replace the strap if any of
these conditions exist.
When trailering, secure the front of the boat to the trailer with a safety
chain or tie-down strap, together with the winch strap. Do not depend
on only the winch strap to hold the bow of the boat on the trailer.
Secure the stern of the boat to the trailer with gunwale or transom
straps. Check the tightness of all retention straps within the first few
miles of your trip.
Be sure the winch strap is kept dry and clean during storage.
®
INSTALLATION
98-08
CAUTION:
Prior to installing the new strap, remove the old cable, rope or strap
and be sure the winch is in good working order with no exposed
sharp edges.
Tail-end straps:
Insert tail-end of strap through the holes in the side of the winch drum.
Cut-end straps:
Fold the cut-end of the strap and insert it through the holes in the
side of the winch drum (See Fig. 1).
Figure 1
Start the strap in the first hole inside of winch drum, then out and into
the next hole. The strap must be threaded into at least two holes–four
is best. If no holes are in the side of the drum you must drill a
minimum of two 1/2'' holes to attach strap.
Advertisement
Summary of Contents for Attwood 11136
- Page 1 America’s best-known boat manufacturers as original equipment. sharp edges. Look to Attwood for quality replacement parts and marine accessories. Tail-end straps: SAVE THESE INSTRUCTIONS Insert tail-end of strap through the holes in the side of the winch drum.
- Page 2 — including but not limited to commercial, racing, or non-marine use — are not covered under this warranty. Attwood’s obligation under this warranty is limited to repair of the product at Attwood’s plant or replacement of the products at Attwood’s option without expense to the original consumer purchaser.