Download Print this page

Scale Graphics Spektrum 2.4 Ghz Series Quick Start Manual

Radio system for use with 2.4ghz railboss r/c

Advertisement

Quick Links

Parts Numbers
Transmitters
DX5e
5-Ch
DX4e
4-Channel
DX6i
6-Channel
MLP4DSM
4-Channel
Spektrum Receivers
AR500
5-Channel
DSM2 Compatible Receivers
AR-6100 6-Ch
Orange Rx
6-Channel
Radio System for use with 2.4GHZ RailBoss R/C

Channel Assignments

Mode 1 (Throttle on Right)
Left Stick
Up/Down
Left Stick
Left/Right Sound
Right Stick
Up/Down
Right Stick
Left/Right Momentum
Mode 2 (Throttle on Left)
Left Stick
Up/Down
Left Stick
Left/Right Momentum
Right Stick
Up/Down
Right Stick
Left/Right Sound
Notes:
1) RailBoss will work with 4 channels, but for two train operation you
need 5 channels.
2) Receivers featuring the "SmartSafe" failsafe are not compatible with
the RailBoss (AR600, AR6310, AR6100, and others. During loss of TX
signal, the receiver elevator channel must stop sending pulses (no
output, zero volts).
Recommended Radio System:
Purchase a Spektrum DX5e Transmitter (only) from your local hobby
shop or on-line (about $69).
Purchase DSM2 compatible receivers from G-Scale Graphics to in-
sure compatibility and get the lowest cost (about $15).
Trim Adjustments should be in the center position at all times.
(See Spektrum Tx manual)
Set all Servo Reverser switches to the Normal (down) position.
Set the Hi/Lo Rate switch to HI.
Direction
Fwd/Rev
Bell/Whistle
Speed
0 to 100%
Off/On
Speed
0 to 100%
Off/On
Direction
Fwd/Rev
Bell/Whistle
Rx
Elevator
ELEV
Rudder
RUDD
Throttle
THRO
AILE
Aileron
Throttle
THRO
Rudder
RUDD
Elevator
ELEV
AILE
Aileron

Advertisement

loading

Summary of Contents for Scale Graphics Spektrum 2.4 Ghz Series

  • Page 1: Channel Assignments

    Purchase a Spektrum DX5e Transmitter (only) from your local hobby shop or on-line (about $69). Purchase DSM2 compatible receivers from G-Scale Graphics to in- sure compatibility and get the lowest cost (about $15). Trim Adjustments should be in the center position at all times.
  • Page 2 Radio System for use with 2.4GHZ RailBoss R/C This information is provided as a service to our customers. We do not sell this product. Binding Procedure “Binding” is the process of sending a code from the transmitter to the re- ceiver.

This manual is also suitable for:

Spektrum dx4eSpektrum dx6iSpektrum mlp4dsmSpektrum orange rxSpektrum ar500Spektrum dx5e