Wiring Instructions 92 and 93 Series
20 Function Receivers
1
Identify the components
Parts included in your kit.
1 x Receiver
1 x Transmitter complete with
1 x Lo-Cover
1 x Lanyard
Indicator LED - Master
LED's indicate the following
LED marked "5V" indicates
power supply for control circuits
is OK
LED marked "SET" indicates the
system active.
LED marked "Fault" indicates an
overload is present; the system
cannot be reset until overload is
removed.
This LED blinks for 20 seconds
when the system is initially
powered. A replacement
Transmitter (or Keypad or Wired
Remote) has to be registered
during this 20 second period.
LED's marked F1 to F16 and M
(and optional MC) when ON
indicate an output to that function
(MC is an extra Continuous
Master output)
Items not shown
2 x Cable Glands
1 x 9863 External Aerial
These instructions
(6 pages)
5 Volts LED
2
IDENTIFY POWER CONNECTION POINT
AND ISOLATE SUPPLY
Remove fuse
Fuse
or Disconnect Battery
!
WARNING
Vehicle batteries contain gasses
which are flammable and explosive.
Wear eye protection and do not lean
over battery while disconnecting. Do
not wear metal jewellery.
3
!
CAUTION
TAKE TIME TO LOCATE THE BEST POSITION
If necessary power the Receiver and move it around
the vehicle until the required performance is achieved
Operate the Transmitter and observe the Receiver
internal LED's.
Mount as HIGH as possible
AVOID surfaces with HEAVY VIBRATION
AVOID DIRECT SPRAY from wheels
In a HOT CLIMATE fit in a SHADED position
Cable gland should face DOWN or BACK
Indicator LED's 1 through 20
9220RX.01E
Set LED
Fault LED