Advertisement
Quick Links
Wiring Instructions 92 and 93 Series
20 Function Receivers
1
Identify the components
Parts included in your kit.
1 x Receiver
1 x Transmitter complete with
1 x Lo-Cover
1 x Lanyard
Indicator LED - Master
LED's indicate the following
LED marked "5V" indicates
power supply for control circuits
is OK
LED marked "SET" indicates the
system active.
LED marked "Fault" indicates an
overload is present; the system
cannot be reset until overload is
removed.
This LED blinks for 20 seconds
when the system is initially
powered. A replacement
Transmitter (or Keypad or Wired
Remote) has to be registered
during this 20 second period.
LED's marked F1 to F16 and M
(and optional MC) when ON
indicate an output to that function
(MC is an extra Continuous
Master output)
Items not shown
2 x Cable Glands
1 x 9863 External Aerial
These instructions
(6 pages)
5 Volts LED
2
IDENTIFY POWER CONNECTION POINT
AND ISOLATE SUPPLY
Remove fuse
Fuse
or Disconnect Battery
!
WARNING
Vehicle batteries contain gasses
which are flammable and explosive.
Wear eye protection and do not lean
over battery while disconnecting. Do
not wear metal jewellery.
3
!
CAUTION
TAKE TIME TO LOCATE THE BEST POSITION
If necessary power the Receiver and move it around
the vehicle until the required performance is achieved
Operate the Transmitter and observe the Receiver
internal LED's.
Mount as HIGH as possible
AVOID surfaces with HEAVY VIBRATION
AVOID DIRECT SPRAY from wheels
In a HOT CLIMATE fit in a SHADED position
Cable gland should face DOWN or BACK
Indicator LED's 1 through 20
9220RX.01E
Set LED
Fault LED
Advertisement
Related Manuals for Lodar 92 Series
Summary of Contents for Lodar 92 Series
- Page 1 9220RX.01E IDENTIFY POWER CONNECTION POINT AND ISOLATE SUPPLY Wiring Instructions 92 and 93 Series Remove fuse 20 Function Receivers Fuse Identify the components or Disconnect Battery Parts included in your kit. Items not shown 2 x Cable Glands WARNING 1 x Receiver 1 x 9863 External Aerial Vehicle batteries contain gasses 1 x Transmitter complete with...
- Page 2 OVER-TEMPERATURE CAN CARRY 15 AMPS (THIS IS THE MAXIMUM etc. If the chassis is SAFETY FEATURE TOTAL CURRENT THAT LODAR CAN SWITCH) GROUND, then a return OVER THE DISTANCE FROM THE BATTERY The Receiver switches itself off wire is not required.
- Page 3 L2 = LIMIT 2 JUMPER may be BLUE LK1, when bridged causes the Master Output to be Parallel LK2, when bridged causes the Master Output to be Continuous JUMPER MUST BE FITTED FOR LODAR TO WORK POWER DOWN RECEIVER BEFORE MAKING CHANGES...
-
Page 4: Final Check
Outside the EEC - If you wish to discard this product please contact your local authorities and ask for the correct method of disposal Lodar 9100 Series is guaranteed for a period of 24 months from the date of purchase, as long as it is wired in accordance... - Page 5 Express Warranties. Seller warrants that the Lodar is as described in the “Lodar Owners Manual” provided herewith: no other express Warranty is made in respect to the Lodar. If any model or sample was shown to you, such model or sample was used for illustrative purposes only, and shall not be construed as a Warranty that the Lodar will conform to the sample or model.