Installation instructions for Sliding Cavity Door Lock
386 Square Passage Set and 396 Circular Passage Set
Step 1. Door Preparation
• Fold template where indicated.
• Position template on door edge
at desired latch height.
• Firmly hold template and mark
pull tab plate height and
escutcheon hole centre at
required backset. (refer template).
• Measure door thickness and mark
centre.
• At required backset drill pilot hole
– suggested size 3mm (1/8").
• Enlarge hole to 54mm (2 1/8") as
required, drilling from both sides
of the door.
Note: Installation instructions also
apply to 386 Square Sliding Cavity
Door Passage Set
installation template for
sliding cavity door passage set
Step 2. Pull Tab Plate Installation
Step 3. Final Assembly
FOLD HERE
"
54mm (2 1/8
)
hole
(Refer to drawing on reverse)
• Mark and chisel latch faceplate (1)
to a recess of 4mm. Use faceplate
as a template.
• Fasten with two screws (2)
provided. If pull tab (3) doesn't move
freely unscrew plate and clear wood
from behind the pull tab hinge.
• Refasten and check pull tab is free.
• Assemble the external escutcheon
(4) with posts for screws to the door.
• Assemble to internal escutcheon
with screw holes to the door (5).
• Fasten escutcheons with screws (6)
provided.
Installation template for
Sliding Cavity Door Lock
Gainsborough Hardware Industries Limited,
Melbourne, Australia. A.B.N. 25 004 792 269
www.gainsboroughhardware.com.au
PAIT ???