California Faucets Steampunk Bay 8508 Installation Instructions

CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:
Recommended Supply Pressure:
Maximum Flow Rate:
Operating pressures between hot and cold supplies should vary no more than 30 psi.
*
If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (PRV).
†
1
INSTALLING SPOUT
•
Tub/Deck recommended hole size shall be Ø1-3/8"
•
Apply Teflon ® tape (13) (not supplied) to threaded
portion of SPOUT (1) and securely tighten NIPPLE
(2) to SPOUT (1)
•
Remove WASHER (3) and NUT (4) from NIPPLE
(2)
•
Slide NIPPLE (2) though SPOUT ESCUTCHEON
(5) and through tub/deck hole
•
From underside place WASHER (3) onto NIPPLE
(2) and secure spout into place with NUT (4)
2
INSTALLING VALVE
•
Tub/Deck recommended hole size shall be Ø1-3/8"
•
From underside insert
appropriate tub/deck hole
IMPORTANT: VALVES (6) are labeled as follows:
BLUE is COLD left turning (counter-clockwise) closed
RED is HOT right-turning (clockwise) closed
•
Position FLANGE NUT (8), WASHER (9), and CUP
SPACER (10) so that VALVE (6) extends 1-1/2"
above tub/deck surface
•
Attach INVERTED NUT (7) to VALVE (6)
•
Use HANDLE (12) to confirm proper VALVE (6)
alignment, rotate VALVE (6) if necessary
NOTE: See image in Section 4 to confirm proper alignment of other
handles
8508_ii_190227
Steampunk Bay
8508, 8508B, 8508W
8608, 8608B, 8608W
Roman Tub Set
Installation Instructions
BY A LICENSED PROFESSIONAL
20 to 70 psi
15 gpm
VALVE (6) though
TM
*†
1
13
2
3
4
2
3
4
10
8
Ø1-3/8"
7
1-1/2"
9
6
1
2
5
12
6
Pg 1