Vestil LO-DC-MR-A Owner's Manual

VESTIL MANUFACTURING CORPORATION
2999 North Wayne St., Angola, IN 46703
Phone (260) 665-7586 · Fax (260) 665-1339
E-mail: sales@vestil.com · www.vestil.com
Ergonomic Solutions
Contents
Safety Precautions ........................................ 1
Receiving Instructions ...................................1
Warranty ........................................................1
SAFETY PRECAUTIONS
Read owner's manual completely before operating unit!
• Never exceed the maximum capacity of 1,000 pounds.
• Never load more than one drum at a time.
• Never load the unit unless you are watching it.
• Stand clear of drum while loading and unloading.
• Drum must be pushed all the way to the back of the
craddle before moving.
• Use caution in moving a loaded unit; avoid obstructions
and floor defects.
• Wear steel-toe shooes when operating.
RECEIVING INSTRUCTIONS
Every unit is thoroughly tested and inspected prior
to shipment. However, it is possible that the unit may incur
damage during transit. If damage is noticed when unloading,
make a note of it on the BILL OF LADING. Remove all
packing and strapping material, then inspect the unit again
for damage. IF DAMAGE IS EVIDENT, FILE A CLAIM WITH
THE CARRIER IMMEDIATELY!
WARRANTY
This product is warranted for 90 DAYS from date of
purchase to be free of manufacturing defects in material and
workmanship.
This warranty does not cover normal wear of parts
or damage resulting from any of the following: negligent use
or misuse of the product, use or application contrary to
installation instructions, or disassembly, repair or alteration
by any person prior to authorization from a factory
representative.
Revised 0507
A company dedicated to solving ergonomic and material
handling problems since 1955 .
OWNER'S
MANUAL
LO-PROFILE DRUM CADDIES
MODELS LO-DC-MR-A, LO-DC-PU-A & LO-DC-CI-A
MODELS LO-DC-MR, LO-DC-PU, LO-DC-CI & LO-DC-PH
Assembly Instructions .................................... 1
Operation ....................................................... 1
Parts List & Drawing ................................2 & 3
ASSEMBLY INSTRUCTIONS
1) Attach casters using hardware included.
2) Bolt wheel assembly to cradle using hardware included.
3) Slide Handle into Wheel Assembly
(Please refer to the next page for the assembly drawing)
OPERATION
1) Align unit in front of drum, remove handle, grip drum with
handle.
2) Tip drum up while guiding the cradle under the drum.
3) Reattach handle and transport drum to desired location.
LO-PROFILE DRUM CADDIES
MODELS LO-DC-MR-A, LO-DC-PU-A
& LO-DC-CI-A
16-126-104
1