INSTALLATION AND ASSEMBLY INSTRUCTIONS WHAT COMES IN THE BOX: PLEASE READ ENTIRE DOCUMENT BEFORE INSTALLATION HB100, 150 and 200 SL series luminaires with and without dimming. Standard: Glass lens (frosted and clear) suitable for wet locations (IP66 rated). Optional: Shatterproof polycarbonate lens (frosted and clear) suitable for wet locations (IP66 rated). Note: Save these instructions for future reference.
High Bay Luminaire should be mechanically supported by chain or cable by securing to snap-lock hook or optional round hook Litetronics part # HBAM20 on top of fixture. 3. When installing without dimmer (0-10V) in wet locations: Ensure that white/gray and blue/purple wires are each covered with a waterproof nut (supplied).
Section 1 Section 2 INSTALLATION PROCEDURE- BASE PRODUCT INSTALLATION PROCEDURE Input 120V or 277V using 3 strip wires with or without 0-10V dimmer OPTIONAL ACCESSORY - Yoke Mount: HBAM23 and HBAM35 HBAM23 HBAM35 Connect wire cord to AC branch circuit as per following. It 9”...
Page 5
This information is subject to change without notice and without incurring liability. If you have questions regarding specific product details, please contact us at 800-860-3392 or via email at customerservice@litetronics.com. To check for an updated version of these instructions, v3 (10-17-18) please visit www.litetronics.com.
This manual is also suitable for:
Led round high bay hb150 sl seriesLed round high bay hb100 sl seriesLed round high bay hb200 sl series