Advertisement
Quick Links
**ALWAYS WEAR A GOVERNMENT APPROVED FLOATATION DEVISE.**
**KNOW YOUR PHYSICAL ABILITY AND THE LIMITS OF YOUR EQUIPMENT!**
The AlterEgo I/II containes:
• 1 – AEI/AEII inflatable Kayak • 1 or 2 – Chairs • 1 – Repair Kit
Kayak Inflation
Inflate the kayak using a hand pump or an electric pump designed for inflatable boats. If using an
electric pump first, a hand pump must be used to top off the kayak. Pumps sold separately.
To inflate:
1. Unroll the boat on a smooth surface.
2. Attach the skeg(if desired) to the bottom of the boat by folding the hull. The skeg cannot
be installed once the kayak in fully inflated.
3. Remove the cap from the valve on a chamber of the boat.
4. Push and turn the valve stem 1/4 turn to the left. This positions the valve stem in the up or
closed position. Having the valve stem in the closed position allows air to be pumped into
the chamber and will prevent the air from escaping.
5. Insert the pump hose/adapter into the valve on the boat.
6. Inflate the boat chamber to a very soft pressure.
7. Repeat procedure for the other chamber.
8. Place the boat's floor inside the boat with the foot braces in front and position so the floor
lines-up with the bailing holes. When correctly aligned, completely inflate the floor
making sure it fits snuggly at the base of the side tubes. Tighten straps to secure the floor
to the boat.
9. Once all chambers are softly inflated, top off all chambers to 2.5 psi with a hand pump.
The floor can be inflated to 7 psi.
If you do not have a pump gauge to check boat pressure, push down with your finger at the center
of the tube, if you can deflect approximately half an inch from the top plane of the chamber it will
be close to 2.5 psi.
Do not over inflate your kayak. Also, increases in temperature and elevation will cause the
air inside the boat to expand, which could cause the kayak to burst. Always monitor and
release some pressure when these conditions occur.
AlterEgo I & II
Safety First!
CAUTION:
Advertisement
Summary of Contents for Zoik AlterEgo I
- Page 1 AlterEgo I & II Safety First! **ALWAYS WEAR A GOVERNMENT APPROVED FLOATATION DEVISE.** **KNOW YOUR PHYSICAL ABILITY AND THE LIMITS OF YOUR EQUIPMENT!** The AlterEgo I/II containes: • 1 – AEI/AEII inflatable Kayak • 1 or 2 – Chairs • 1 – Repair Kit Kayak Inflation Inflate the kayak using a hand pump or an electric pump designed for inflatable boats.
- Page 2 Drain Valves The AlterEgo I and II come equipped with 8 or 12 removable drain valves respectively. These drain valves allow your kayak to be paddled dry in flat water conditions and as a self-bailing boat in whitewater.
- Page 3 How to fix a leak on the river (temporary repairs)? 1. Included with each new Zoik Inflatable is a repair kit containing a tube of one part glue, a small piece of fabric the same color as your boat and a valve wrench.
- Page 4 What your Warranty DOES Cover: The 2, 3, and 5 year warranties cover all retail purchases on all Zoik products against • manufacturing defects in materials and craftsmanship. This warranty covers the fabric, seams, handles, and D-ring patches.