3 metres. We have complete confidence in this Tavistock product and as such it is offered with a 10-year guarantee against defects in manufacture. This valve must be fitted by a competent installer. If in doubt seek advice from CONDITIONS OF USE FOR TYPE 2 VALVES a qualified professional.
Page 3
COMMISSIONING VALVE INSTALLATION GUIDELINES AND COMPLIANCE The valve must be installed so that it is readily accessible for commissioning and maintenance in accordance with the TMV2 scheme. The valve must be installed with isolation valves on both the hot and cold water It is important that incoming water supplies conform to the requirements specified for pressure and systems as close as possible to the valve;...
If further maintenance should be required contact Tavistock for details. Please see contact details on the back page of this document.
Page 5
FITTING OPTION 2 KINETIC BOTTOM OUTLET BAR VALVE SHOWN MAX cut diameter = 45mm Threaded connector Fully tighten the threaded connector so the olive compresses and rmly 15mm pipe locks the pipe in position. Olive...
SETTING THE TEMPERATURE OPERATING KINETIC BOTTOM OUTLET BAR VALVE SHOWN KINETIC BOTTOM OUTLET BAR VALVE SHOWN decrease temperature Increase flow Increase temperature The handle on the right of the valve controls the water temperature. To adjust the temperature: 1. Unscrew the handle arm (1) on the temperature handle (3) to reveal the handle grub screw (2). Using a decrease flow suitable allen key loosen the grub screw and carefully slide the handle off the thermostat spindle (5).