LOCKEY USA 1150 Installation Instructions

No. Part Name
1 Outside Body
2 Inside Body
3 Rubber Trim Plate
4 Adjustable Latch
5 Strike Plate
6 Mortised Striker
7 Spindle
8 Support Pin
9 Tapping Screws
10 M5 x 55m Screws
11 M5 x 45mm Screws
12 Tweezers
13 Red "Code" Tumblers
14 Blue "Non-Code" Tumblers
1. Use the template provided and confirm the back set on the surface and the reverse side.
2. Decide the position for the lock and mark holes as instructed by template. Drill holes.
3. Insert the Adjustable Latch into the slot. Trace line around the Latch face and remove it.
4. Chisel until the Adjustable Latch face is flush with the surface of the door edge.
5. Fasten Adjustable Latch with the tapping screws.
Important: Ensure the Adjustable Latch face is evenly fitted.
6. Break the spindle to the correct length according to the door thickness.
7. Determine Door Handing: Right-Hand Doors – From exterior of door, hinges are on right-side
(fig. 1). Left-Hand Doors – From exterior of door, hinges are on left-side (fig. 2). To change hand-
ing, remove screw on back of lever, then remove plate on lever. Remove two screws from lever
handle, lift lever up and switch direction of handle. Replace screws and plate, fasten.
8. For right hand doors, install Support Pin in hole on left side of back of the Outside Body.
For left hand doors, install Support Pin in hole on the right side of the back of the Outside Body.
9. Fit Rubber Trim Plate on the backside of the Outside Body, then hold Outside Body on door,
with 4 hex bolts and Support Pin through the holes in door.
10. From inside of the door, insert Spindle through the hole in the Adjustable Latch & into hole
on backside of Outside Body.
IMPORTANT: Right hand doors: Spindle must be at a 2:00/8:00 angle from the inside of the
door (Fig. 4). Left hand doors: Spindle must be at 10:00/4:00 angle from the inside of the door.
11. Fit Rubber Trim Plate to the Inside Body and fit Inside Body over the Spindle, ensuring that
Spindle angle remains correct.
12. Select Machine Screws based on door thickness and fasten them through the Inside Body.
IMPORTANT: Before closing the door, test the operation of the lock.
From Outside of Door:
1. Press "C" button, followed by your code.
2. Turn the handle.
3. Confirm that the latch head retracts smoothly.
From Inside of Door:
1. Turn the handle and ensure the latch retracts smoothly.

INSTALLATION INSTRUCTIONS

# Included
1
1
s
11
2
1
1
1
1
1
4
4
4
1
1
2
Instructions continued on reverse
1150 & 1600
k
l
m
r
o
n
Insert support pin
(Right Hand Door)
View from Inside (Right Hand Door)
l
j
p
13 14
12
q
Back of Outside Body (Fig. 3)
Support Pin Holes
(Fig. 4)
2:00
8:00