WAC Lighting HTK-793 Instructions

INSTRUCTIONS
Models:
Caution:
Read all instructions before installing.
Switch off power before installing or re-lamping.
Do not attempt to energize anything other than a track light fixture.
All installation shall be in accordance with NEC and all local codes.
To reduce the risk of a burn during re-lamping, remove from the track before re-lamping.
Overview:
Fixtures are designed for use on "HT" series WAC Lighting track. They may also be used on other
manufacturer's brand of track (consult factory for compatibility).
Lamping:
1. HTK-793 use PAR 20 lamp, 50W max.
HTK-794 use PAR 30 lamp, 75W max.
HTK-795 use PAR 38 lamp, 150Wmax.
2. Insert the PAR lamp by screwing clockwise
into lamp socket.
Fixture Installation:
1. Note the track head contacts, and the polarity groove
running the length of the track.
2. The two contacts should be positioned so that when
rotated, they will face the grooved side of the track (this
is the side with two flat copper wires running its length).
3. Insert adapter into track slot. Pull downward on the
adapter while rotating the adapter 90º.
4. Release the adapter so the locking tab seats in the
track slot.
5. Removal is the reverse procedure. Track heads may
be positioned anywhere along the track length.
6. Not suitable for use on wall mounted track.
Retain instructions for future reference.
Line Voltage Track Fixture
HTK-793 HTK-794 HTK-795
Retain these instructions for future service and adjustments
615 South Street, Garden City, NY 11530
Tel: (516) 515-5000 Fax (516) 515-5050
www.waclighting.com