Lithonia Lighting LVS 120/277 ELN CW Installation Instruction Supplement

INSTALLATION INSTRUCTIONS SUPPLEMENT INSTALLATION INSTRUCTIONS SUPPLEMENT INSTALLATION INSTRUCTIONS SUPPLEMENT INSTALLATION INSTRUCTIONS SUPPLEMENT INSTALLATION INSTRUCTIONS SUPPLEMENT
EXTREME EXIT SIGNS COLD WEATHER OPTION EXTREME EXIT SIGNS COLD WEATHER OPTION EXTREME EXIT SIGNS COLD WEATHER OPTION EXTREME EXIT SIGNS COLD WEATHER OPTION EXTREME EXIT SIGNS COLD WEATHER OPTION
CAUTION: CAUTION: For safety and proper operation, read and follow instructions carefully before installation. CAUTION: CAUTION: CAUTION:
Figure A
120V Single Lamp
SINGLE FACE MODEL LVS 120/277 ELN CW SINGLE FACE MODEL LVS 120/277 ELN CW SINGLE FACE MODEL LVS 120/277 ELN CW
SINGLE FACE MODEL LVS 120/277 ELN CW SINGLE FACE MODEL LVS 120/277 ELN CW
PARTS DESCRIPTION PARTS DESCRIPTION
PARTS DESCRIPTION PARTS DESCRIPTION PARTS DESCRIPTION
Charger PC Board
Battery
Battery Heater
Heater Capacitor
Thermostat
Thermostat Cover
Battery Bracket
Pushnut Connector
Battery Insulator
Note: Jumper wire must be
installed for 120v operation
IMPORTANT SAFEGUARDS IMPORTANT SAFEGUARDS
IMPORTANT SAFEGUARDS IMPORTANT SAFEGUARDS IMPORTANT SAFEGUARDS
1.READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
2. Before wiring to power supply, turn off electricity at fuse or
circuit breaker.
3. Disconnect A.C. power before servicing.
4. All servicing should be performed by qualified personnel.
5. Consult your local building code for approved wiring and
installation.
6. Do not mount near gas or electric heater.
7. Fixture must be grounded to avoid potential electric shock.
8. Equipment should be mounted in location and at heights where
it will not readily be subjected to tampering by unauthorized
personnel.
9. The use of accessory equipment not recommended by the
manufacturer may cause an unsafe condition.
10. Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS SAVE THESE INSTRUCTIONS
SAVE THESE INSTRUCTIONS SAVE THESE INSTRUCTIONS SAVE THESE INSTRUCTIONS
INSTALLATION INSTALLATION INSTALLATION INSTALLATION INSTALLATION
Single Lamp (LVS): Single Lamp (LVS): Single Lamp (LVS): Single Lamp (LVS): Single Lamp (LVS):
1. Refer to main installation manual for all mounting and
additional instructions.
2. Select the appropriate wiring diagram for the correct input
voltage. Important Note: Important Note: When wiring for 120V operation, the Important Note: Important Note: Important Note:
supplied black jumper wire must be used.
Figure B
277V Single Lamp