Advertisement
Quick Links
Repair Instructions
Replacing and Installing a 10 Function Remote.
Step
Description
Models that Apply: EL02.10 (Elite two purchased with 10
function remote.), EL03.10 (Elite three purchased with 10
function remote.).
Open the control panel by unscrewing the (4) Phillips-
1
head screws in each corner of the control panel.
Gently pull the control panel out, and allow it to rest
2
below the opening in the red case.
Remove the protective strip from the adhesive side of
the Velcro strip.
3
Author: LS/RR/JJ
Contributors: CT
Tools
Phillips
Screw
Driver
Date: 10/12/16
Picture
Control Panel
Control Panel Removed
Velcro Strip/ Remote
Receiver
Revised:
Advertisement
Related Manuals for LOBSTER SPORTS Elite Series
Summary of Contents for LOBSTER SPORTS Elite Series
- Page 1 Repair Instructions Replacing and Installing a 10 Function Remote. Step Description Tools Picture Models that Apply: EL02.10 (Elite two purchased with 10 function remote.), EL03.10 (Elite three purchased with 10 function remote.). Phillips Open the control panel by unscrewing the (4) Phillips- Screw head screws in each corner of the control panel.
- Page 2 Repair Instructions Replacing and Installing a 10 Function Remote. Place the remote control receiver against the left side of the case near the center. Press the remote control receiver firmly against the left side of the case with the single antenna wire facing forward and the wire connector, to the rear.
- Page 3 Repair Instructions Replacing and Installing a 10 Function Remote. Ensure all wires are connected, and reattach the control panel to the red case using the (4) Phillips-head screws. Take extra caution to feed all wires into the case and ensure no wires are trapped between the control panel and the red case.