EBS Nitro Infuser-Dual Installation Instructions

Provided T
Fitting
Beverage
Keg A
Step 1: Preparation
If you are installing your Nitro Infuser in an existing system, the nitrogen gas must be shut off and the system depressurized,
including the kegs. Open the tap faucet to release pressure. Set the regulator to 0 psi.
Step 2: Identify Mounting Location for Nitro Infuser
The Nitro Infuser will be mounted within the kegerator, on the tap lines from the kegs to the tap faucets. Placement of your Nitro
Infuser on the inside wall of the kegerator near the top is ideal. For best performance, the Output lines to the faucet should be as
short as possible.
*Please note, infusing a beverage with nitrogen causes the liquid to freeze faster. To prevent freezing, install your infuser further
from the cooling mechanism (typically found near the back of the kegerator). Refer to your owner's manual to ensure there is no
electricity or cooling element behind selected location.
www.enhancedbeveragesolutions.com | @enhancedbeveragesolutions | #TapCulture
© Enhanced Beverage Solutions | June 2019 | Revision 2.002 | Patent Pending | Made in U.S.A.

INSTALLATION INSTRUCTIONS

Thank you for purchasing a Nitro Infuser Dual!
Follow the instructions below to get started.
Installation videos and manuals may be found at:
www.enhancedbeveragesolutions.com/support
Gas A
Beverage A
Beverage B
Gas B
Provided T Fitting
Beverage
Keg
Beverage
Keg B
NCS NCS
Output A
Output B
NCS
28 psi
Nitrogen
Gas
Provided T Fitting
-DUAL
To Faucet
To Faucet
Kegerator
Continued...
Stout Faucet