Advertisement
Quick Links
EMERGENCY LIGHT WITH PHOTOSENSOR
INSTALLATION AND OPERATING INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS:
When using electrical equipment, basic safety precautions should always be
followed including the following:
1. Disconnect power at fuse or circuit breaker panel before installing or servicing
of the unit.
2. DO NOT mount in hazardous locations, near gas or electric heaters.
3. DO NOT let power cords touch hot surfaces.
4. Equipment should be mounted in locations and at heights where it will not be
readily subject to tampering by unauthorized personnel.
5. The use of accessory equipment not recommended by the manufacturer.
Use of such equipment may cause unsafe conditions, and will void the unit's
warranty.
6. DO NOT use this equipment for other than it's intended purpose.
7. All servicing should be performed by a qualified personnel only.
8. Allow battery to charge for 24 hours before first use.
SAVE THESE INSTRUCTIONS
CONSERVER LA FICHE D'INSTRUCTION
H3 GROUP
WET LOCATION LUMINAIRE AND
SERIES: WW - OWL - ODELL
IMPORTANT SAFEGUARDS
1
Advertisement
Summary of Contents for H3 Group WW Series
- Page 1 H3 GROUP WET LOCATION LUMINAIRE AND EMERGENCY LIGHT WITH PHOTOSENSOR SERIES: WW - OWL - ODELL INSTALLATION AND OPERATING INSTRUCTIONS IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS: When using electrical equipment, basic safety precautions should always be followed including the following: 1.
- Page 2 SECTION 1: BASIC FUNCTIONALITY AND FEATURES Open enclosure using flat blade screw driver to access knockouts. Housing / Front Cover Photosensor Rear Panel LED Array Test switch/ Status Indicator (EM Models Only) Figure 1 Prior to removing knockouts, support rear panel on a base to prevent panel deflection and/or damage to the cover’s flatness.
- Page 3 SECTION 3: LUMINAIRE WITH AC ONLY OPERATION WIRING INSTRUCTION 1. For wall mount, secure backplate to junction box (screws provided with junction box), and feed input source wires through center hole in rear panel. Note: this unit has a wide input range, 120V-277V, eliminating the need for special wiring based on the input voltage.
- Page 4 SECTION 4: EMERGENCY (EM OPERATION) LIGHT WITH BATTERY BACKUP WIRING INSTRUCTIONS 1. For wall mount, secure backplate to junction box (screws provided with junction box), and feed input source wires through center hole in rear panel. Note: this unit has a wide input range, 120V-277V, eliminating the need for special wiring based on the input voltage.
- Page 5 SECTION 5: AC ONLY OPERATION WITH PHOTOSENSOR On the LED driver module, there is a slide switch that must be positioned to the right (factory default setting) to allow the unit to utilize the photosensor capabilities (and optional passive infra-red sensor). LED Driver Module Slide Switch Original position for photosensor...
- Page 6 SECTION 9: HEATER PAD CONNECTION INSTRUCTION If unit heat pad option for cold weather, INSTALLER MUST VERIFY AC INPUT SOURCE VOLTAGE TO DETERMINE APPROPRIATE WIRING PRIOR TO TURNING THE FIXTURE ON. Refer to the instructions below for voltage dependent instructions: WARNING: DAMAGE MAY OCCUR IF HEAT PAD IS WIRED INCORRECTLY FOR 277VAC OPERATION.
-
Page 7: Section 11: Testing And Trouble Shooting
SECTION 10: SELF DIAGNOSTICS/ SELF -TESTING OPTION DIAGNOSTIC CODES 1.When AC Power is supplied to fixture, the unit will automatically initiate a self-test and self diagnostic test as follows: A). Verifies battery connection, charger board failure, lamp failure and transformer failure every 4 seconds.