Page 1
Revised December 2014 *Grab bar not included 01-010/01-011 Rear Flip Seat WILL FIT E-Z-GO ® ® installation instructions included: HD Bracket 2 Seat 2 Footrest Lean Back Cushion Back Brackets Brackets 2 Brackets Seat Back Support Bracket Seat Bottom Cushion...
Page 2
Mount lean back brackets to main brackets as shown with hardware from Pack 1. Attach rear struts using retained hardware from Step 1. Tighten hardware. Attach motor cover using hardware retained from Step 1. Remove outermost bolts in bagwell and attach bagwell bracket using same hardware.
Page 3
Attach seat frame to bagwell brackets using hardware from Pack 2. Attach seat frame to brackets using remaining hardware from Pack 2. Tighten hardware. IMPORTANT: Do not tighten hardware until Step 14 is complete. Attach armrests and seat back support using hardware from Pack 3 as shown.
Page 4
Attach footrest and footrest brackets using hardware from Pack 4. Attach seat back brackets to seat back using hardware from Pack 5. Attach front seat back to brackets using retained hardware from Step 1. Attach seat back to seat back support using hardware from Pack 2.
1. Place HD bracket on flip seat as shown. Align bracket holes to the flip seat mounting holes. Make sure the thickest part of the seat bottom points towards the footrest. Center seat bottom from left to right on flip frame. Press cushion firmly against HD bracket and seat frame.
® any of Textron’s trademarks, word marks, or products is only for purposes of identifying golf carts with which this Madjax product is compatible. Madjax products are aftermarket parts and are not original equipment parts. Madjax is not connected to, affiliated with, sponsored by, or endorsed by Textron or...