Tamarack Technologies HV1000 Installation Instructions

It is strongly recommended that this kit be installed by a qualified professional. Some state and local codes require
electrical wiring be performed by a licensed electrician. Check with your local code officials before installation.
Part Number: TTi-HVRC
The HVRC includes the following items:
Qty Description
1 Black box with cover and hardware
1 Romex Clamp
1 2" Lg. Velcro Strip
1 3/4" Lg. Protective Sleeve
3 Yellow Wire Nut
1 Handheld Transmitter
Flat Head Screwdriver - Phillips Head Screwdriver - Needle Nose Pliers
Remove the cover from the junction box mounted on the HV1000 Whole
House Fan. Remove the knock-out on right side of the junction box. Place the
black box on the HV1000 mounting flange. Insert the Romex clamp into the
holes with the clamp side in the black box. Thread the nut onto the clamp and
tighten.
(Figure 1)
Slide the 3/4" protective sleeve over the White, Black, Red and Green wires in
the black box. Insert the wires through the clamp. Slide the sleeve into the
clamp and tighten.
(Figure 2)
Attach the Green ground wire inside the black box and the home power
supply to the ground screw in the junction box.
(Figure 3)
Tamarack Technologies, Inc.
HV1000 Remote Control Installation Instructions
Tools Required
Figure 1
Figure 2
Figure 3
508-759-4660 / Fax 508-759-6001
HVRC.3