Summary of Contents for Battenfeld 22280
- Page 1 Vault Accessories Deluxe Kit Instructions #1031640 Product #222498 A. Hygrometer B. 12” Dehumidifier C. Large Hanging Organizer D. Cordless Automatic Vault Light E. Magnetic Barrel Rest F. Vault Anchor Kit...
- Page 2 Cordless Automatic Vault Light Instruction #1025374 Rev A Product #222809 Instructions and Usage Location of Controls 1. ON/OFF/DIMMER Switch 4. Light Sensor 2. Battery Compartment* *Underneath unit 3. Light Sensor Switch Installation -- Hook and Loop Tape (included) 1. Check the location of where you want to put the vault light. Make sure it is clean and free of debris or dust.
- Page 3 Cordless Automatic Vault Light Light positioning • The LED Vault Light’s base can be twisted 360°. • Pivot the lens up to 30º to light desired area. ON/OFF/DIMMER Operation • Press power symbol once for full brightness. • Press again for softer light. •...
- Page 4 Dehumidifier Product #222-000 & #222-010 Thank you for purchasing a LOCKDOWN Dehumidifier Rod. When properly used, it will provide you with years of trouble free service. Please read all instructions below before attempting to use the rod. Safety Warnings: - The Dehumidifier Rod is for indoor use only and is not intended for outdoor use.
- Page 5 3. Snap the Rod into the mounting clips. 4. Make sure the end of the wire has a clean cut end. If it does not, cut off a small amount of the cord to achieve a clean end. Do not split the wires, see figure 1. The plug housing has a back cover that will need to be removed, see figure 2.
- Page 6 Large Hanging Organizer Instructions Depending on which interior you have in your vault, slide the clips up into the pockets on the back of the Handgun Hanger. Then, attach hanger wherever you like. Vampire Clips for High strength magnets for fabric interiors.
- Page 7 Hygrometer Instructions Provides accurate Relative Humidity readings from 0% to 100% inside a gun safe. • Mounts easily with included fastener • Large easy-to-read numbers • 2 ¾” diameter Hook & Loop fastener on the back Mount anywhere in your vault that is easily visible. Magnetic Barrel Rest Instructions Magnetic back holds to any magnetic vertical surface.
- Page 8 Vault Anchor Kit Wood Floor Joist or Wall Stud: The Anchor Kit includes Lag Screws and fitted caps for installing a safe to solid wood. This is useful when you are mounting it to wall or to floor joists. The following steps are for installing into a floor joist, but a wall stud can also be used.