B. D Check the existing door for proper operation. If the door does not operate properly, stop installation and contact LockNet immediately. C. R EMOVE EVICE Remove any existing exit hardware from the door.
Page 3
LockNet Security Doors Attach the strain relief on the armored power supply cable through the cover plate for the armored door loop cable. Connect the armored power supply cable and the armored door loop cables using the attached plug-in connectors.
1. Test the system to ensure proper operation of all installed components. 2. Call LockNet to report job completion (after normal business hours you may call LockNet the following business day). 3. When you are satisfied, demonstrate the system operation to the store manager.
Page 5
LockNet Security Doors Program Button Figure 5: Control Module Wiring Diagram LockNet, LLC 800 John C Watts Drive Nicholasville, KY 40356 www.locknet.com 800-887-4307 Document Part # 14003524 (Rev 021919) Page 5 of 5...