ZANDA FUTURA Series Fitting Instructions

Fitting Instructions for Codes: 9036, 9037, 9038, 9040, 9041& 9042.
Suitable for door thicknesses to 55mm.
These handles are designed to be fixed to door with through-fixing bolts and wood screws provided.
Latch
1. Measure the door thickness and mark the centre at desired height for latch.
2. Mark the face of door each side for drilling of spindle and screw holes.
Note: The spindle hole will need to be centred at 60mm from the door edge (backset)
3. Drill a 25mm (1") hole through door edge.
Note: It is important to drill this hole square.
4. Drill a 25mm (1") spindle hole through door face.
Note: For clean cut-outs, drill from both sides, meeting in the middle of door.
Drill 6.0mm holes for through bolts at horizontal position.
5. Remove any loose sawdust and insert latch. Scribe around face, remove, then chisel out recess to enable latch to sit flush with door edge.
6. Insert latch and fasten with screws supplied.
7. Gently close door against frame and mark latch position for fitting of strike plate. Router or chisel so plate fits flush, allowing for plastic
recess box if required.
Handles
1. With latch fitted to door, ensure all holes line up prior to fitting door handles.
2. Remove rose covers from levers.
3. Unthread short screws from threaded sleaves. Insert short-end thru-screws through the two horizontal holes in the rose and tighten to
threaded sleeve.
4. Insert spindle so an even amount protrudes each side of door.
Note: Grooved side of spindle must be aligned with grub screws on levers.
5. Remove long thru-screws. Insert handle from 'step 3' onto spindle.
6. Insert long thru-screws through other half of handle set and slide over spindle. Tighten screws securely.
7. In the top hole on the mounting plate, secure a wood screw. Then press on rose covers and tighten grubscrew on underside of cover
plate for a concealed fix.
8. Tighten the grubscrew on side of levers onto spindle each side of the door.
Note: The grubscrews may need a re-tighten after a bedding-in period. We Recommend Medium Strength Thread-lock to be used,
Windsor Code: 1276.
9. Test door and if necessary, adjust strike tongue to take up any rattle.
Note: Take extra care when working through step 2 of the instructions above when establishing the height & position of handles on the door,
be sure to mark out both sides of the door the same to ensure the handles are even on both sides.
Note: For clean cut-outs drill from both sides, meeting in the middle of door. Drill 6.0mm (or ¼") holes for through door bolts.
©Zanda Pty Ltd – Futura Integrated Privacy Door Furniture Fitting Instructions - Page 1 of 2 (Up-dated Feb 2013)
FUTURA DOOR FURNITURE FITTING INSTRUCTIONS