LITEWAY TLLX-1001 Operating Instructions

WARRANTY
All fiber optic transmission systems, products and accessories
manufactured by Liteway, Inc. and it's subsidiaries are fully tested
prior to shipment and are warranted against defective materials
and workmanship for a period of five full years from the date of the
original shipment. Should a problem occur, a Return Material
Authorization Number (RMA) must be obtained from Liteway Inc.
at (516) 931-2800 and the item returned to Liteway, Inc. 166
Haverford Road, Hicksville, NY 11801, USA, prepaid. Liteway Inc.
will then, at its option repair or replace the defective item.
Liteway, Inc. maximum liability under this warranty is limited to the
cost of the defective item only. No contingent liabilities of any kind
are either assumed or implied.
Any items returned to Liteway, Inc. that have been misused,
abused, damaged, modified, connected or adjusted in any way
contrary to the instructions furnished by Liteway, Inc. or repaired
by unauthorized personnel will not be covered by this warranty.
Any non-warranty repairs required will be quoted at the current
rate for such services.
!
Important Notices
CAUTION ! AVOID DIRECT EXPOSURE TO BEAM.
All –5, -7, -8, and -9 Models use laser diodes. These solid-state
laser diodes are located in the optical ports of these units. Laser
diodes produce invisible radiation that may be harmful to human
eyes. Never look directly into the optical port of any fiber optic
unit designed to operate with single-mode optical fiber.
NOT FOR LIFE SUPPORT SYSTEMS
Liteway, Inc. does not authorize or warrant any of its products or
accessories for use in critical life support systems or applications
of any kind.
© Copyright 2016 Liteway, Inc 106091 Rev F

OPERATING INSTRUCTIONS

Fiber Optic
Telephone
Transmission System
TLLX-1001
TLPX-1001
The TLLX/TLPX-1001 system consists of the TLPX-1001 telephone set
transceiver and TLLX-1001 telephone line transceiver and is intended to
connect a standard US telephone set (tone type only) to a standard US
telephone line via two fiber optic conductors.
Technical Specifications
Audio Bandwidth 300Hz to 3KHz typical
TLLX-1001 Compatibility Standard US tone type telephone set
TLPX-1001 Compatibility Standard US telephone line
Signal/Noise Ratio 50 dB minimum
Electrical Connector Modular RJ11
Optical Loss Budget 10 dB typical
Optical Output -16dBm typical
Operating Wavelength 850nm, 1300nm, or 1550nm
Fibers Accommodated Multimode or Single-mode
Number of Fibers 2
Temperature Range -35º to +75ºC
Power Requirements 11-24 VAC/DC @350 mA max
Physical Size (mm) 5.0"(127)L x 1.0" (25.4)W x 3.0"(7)D
All specifications measured with 1Km of 62.5u multimode fiber and
specifications are subject to change without prior notice.