Imtra OFFSHORE Series Installation Instructions Manual

Package Contents:
• (1) OFS 9LED light fixture with mounting bracket installed
• (2) Hex Head M10 mounting bolt
• (2) Metal Washer
• (2) Nylon Locking Nut
• (2) Isolating PC Spacer Kits
Safety Instructions:
WARNING: RISK OF ELECTRIC SHOCK
• Installation is intended to be done by a qualified electrician in accordance with the control of hazardous energy (lockout/tagout)
safety regulations and procedures.
• Installation must follow the NEC/ABYC/USCG electrical codes set for the specific vessel the fixture is being installed on.
• Ensure ALL POWER SOURCES connected to the room or fixture location are turned OFF before installation.
• Verify input voltage is within fixture range before installation.
• The use of safety equipment (safety glasses and gloves) are highly recommended.
• Avoid mounting near any combustible material and/or heating units.
• Any maintenance/repairs to the fixture may only be carried out by a qualified electrician.
• Allow proper cooling time before handling the fixture if it has been installed & powered.
• Any modifications to the fixture will automatically void warranty.
• Always inspect the fixture for any damage prior to installing and DO NOT install if any damage is present.
© 2019 Imtra Corp. All Rights Reserved | 30 Samuel Barnet Blvd., New Bedford, MA 02745 USA | info@imtra.com | 508-995-7000
Product Summary:
In collaboration with the Vision X engineering team, the Imtra Offshore Series Marine
LED Deck Lights are specifically designed with the extra protections required to
survive life on the open ocean. The stainless-steel brackets, copper circuit boards,
tinned extra-long sheathed cables and marine-grade gloss coating are all there to
protect the fixture from corrosion and other harmful elements encountered on the
water. Additional safeguards such as EMC shielding and transient voltage suppression
set these fixtures far above our competition. Each model is available in several beam
angle configurations from narrow to extra wide flood. We also offer elliptical beam
options for side deck applications.
7
WATT
L.E.D.S
PLEASE READ ALL INSTRUCTIONS BEFORE INSTALLATION
DC
IP-68 IP69K
DIE-CAST
HOUSING
WATERPROOF SPRAY TESTED
Tools Required For Assembly
• 13mm Wrench / Socket OR Philips-Head Screwdriver
• 17mm Wrench
• 17mm Socket Wrench
• Drill with 9/16" size drill bit (if mounting hole is needed)
OFFSHORE SERIES
9LED 11-65V DC
Installation Instructions
11-65V
DC INPUT