Sunbeam 129857 Quick Start Manual

P/N:BCM5555CN/BCM7305RCBCN08EFQSG1/129857/9100030005498
size: 8.5 inch (W) X 11 inch (H)
- 4-C printing
- 95gsm matt coated paper
- Double-sided printing (English Front / French Back)
- 2-fold lea et (fold 2 times, English to outside)
1 .
SET DESIRED
MODE

MODE BUTTON

OFF (OF) HIGH HUMIDITY
MED HUMIDITY (2)
PROVIDES CONTINUOUS
HUMIDITY OUTPUT
Humidity cannot be set
in High, Med or Low setting
AUTO HIGH HUMIDITY
AUTO MED HUMIDITY
AUTO LOW HUMIDITY
AUTOMATICALLY
MAINTAINS SET HUMIDITY
(Go to step 2 SET HUMIDITY)
SET TIMER
Press & Hold
Then using one arrow select desired time
TROUBLE SHOOTING
MIST OUTPUT IS MINIMAL TO NONE
Reason: This humidi er provides a cool, invisible moisture.
It is normal not to see mist.
Solution: Refer to Mode Button section to adjust humidity.
HUMIDIFIER RUN TIME VARIES BETWEEN USES
Reason: Run time for this humidi er is based on average room condition
and can be a ected by temperature, humidity level, room
construction, and air exchange.
Solution: To extend run time, use the Auto mode and set your desired humidity level.
HUMIDIFIER HUMIDITY DOES NOT MATCH ROOM HUMIDITY
Reason: The humidi er can only sense/obtain the humidify level near the
humidi er. Actual room humidity may be slightly di erent.
Solution: Place humidi er in center of room for better circulation.
©2008 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved.
Displays room humidity when
humidi er is plugged in and after setting
mode, humidity or timer.
(3)
LOW HUMIDITY (1)
(A3)
(A2)
(A1)
MODE/OFF BUTTON
Push twice to select Mode;
Hold to turn O
AUTOMATICALLY TURNS HUMIDIFIER ON/OFF
BOTH ARROW BUTTONS
2 .
Room Humidity. Humidi er will not operate
AUTOMATICALLY CYCLES ON/OFF
for 2 SECONDS until 00
(1 hour increments)
HUMIDIFIER CONTINUOUSLY DISPLAYS 21%
Reason: Humidity at the humidi er is at or below 21%
Solution: Continue to operate humidi er to raise the room humidity.
HUMIDIFIER CONTINUOUSLY DISPLAYS 90%
Reason: Humidity at the humidi er is at or above 90%
Solution: Stop operating the humidi er if the humidity level is too high.
If you're still having trouble –
Do not return product to store!
Please call:
P.N. 129857 / BCM5555CN/BCM7305RCBCN08EFQSG1/9100030005498
SET HUMIDITY
ARROW BUTTONS
in A3 (AUTO HIGH),
A2 (AUTO MED) &
A1 (AUTO LOW) ONLY
up down
Default SET HUMIDITY may be less than
in AUTO MODE if the SET HUMIDITY is less
than Room Humidity, adjust as required.
TO MAINTAIN SET HUMIDITY!
In (A3), (A2) & (A1) Mode
TIMER LIGHT
IIIuminates when
Timer is set
blinks.
.
1
800
253
2764