Operational Manual
True Day & Night MICF Camera
Please read the Operational Manual
before attempting to use this product.
FEATURES
1/3" Sony Super HAD CCD
550 TV Lines, HQ-1 DSP
0.15 Lux @ F1.0
Mechanical IR Cut Filter (ICR): As the amount of illumination
decreases, the Mechanical IR Cut Filter automatically switches to
B/W mode to increase light sensitivity for a brighter image. After
illumination regains brightness, the Mechanical IR Cut Filter will
automatically switch from B/W mode to color mode.
Lead (Pb) Free RoHS Compliance
Relatively no interference from magnetic or electrostatic fields.
Dual Power 12V DC / 24V AC
Day Time Mode
(>7 Lux)
DIMENSIONS (Unit: mm)
SHM-7550DN
SHM-7550DNP
Night/IR Mode
(<4 Lux)
NOMENCLATURE AND FUNCTION
1. Lens mount
This mount is used to install a CS-mount lens.
CS-adaptor ring is required if use a C mount lens.
2. Camera mounting screw holes
Screw hole for fixing camera.
3. Mount Adaptor
This adaptor can be attached to either the top or bottom of the unit.
4. Auto Iris Lens Connector (4-pin type)
The lens connector supplies the auto iris lens (not supplied) with DC
power and a video signal or DC control signal.
PIN NO.
VIDEO
1
DC + 12V
2
3
VIDEO SIGNAL
4
5. Control Switch
SW1. SYNC MODE: SYNC Mode Selection INT/L.L. switch.
SW2. AES: Automatic Electronic Shutter OFF/AES switch.
SW3. BLC: Back Light Compensation OFF/BLC switch.
SW4. F.L: Flickerless NOM/F.L switch.
SW5. AGC: Automatic Gain Control OFF/AGC switch.
6. VIDEO connector
This is an output for connection to a video monitor, etc (75ohms).
7. Iris mode selection switch
Used to choose DC or VIDEO mode according to the type of your lens.
8. DC Level adjustment V.R.
Used to adjust video output level of DC driven auto iris lens.
9. Power input terminal
Connect the power supply of 12V DC / 24V AC.
DC
CONTROL -
NC
CONTROL +
DRIVE +
GND
DRIVE -
SHM-7550DN_rev04292008