Quoizel CSE9010EK Assembly Instruction Sheet

6 CORPORATE PARKWAY
, .
GOOSE CREEK SC 29445
. .
www quoizel com
Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: (1) Medium Base 150W bulb Maximum or
(1) Medium Base Vintage Bulb is recommended but not supplied.
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
Mounting
A Screw
x 3
Finial
B
x 1
Water Proof
C Washer
x 1
-
STEP 1 remove Fixture
Hood, Shade and Styrofoam
from Fixture Body
A. Remove Fixture Hood by
unlock Lock Screw from
Fixture Body (G).
B. Remove the Package
Material and Shade inside
the Fixture Body (G).
Figure 1
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
2017 QuoizelInc.
Assembly Instruction Sheet #IS-CSE9010
For Styles CSE9010PN and CSE9010EK
for product cleaning tips. Go to the
30-45 minutes
Lock
D Washer
x 1
Fixture
F Body
x 1
Shade
G
x 1
Lock Screw
Fixture
Hood
Shade
Package
Material
B
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
Care + Maintenance selection.
-
STEP 2 Install Shade, Fixture
Hood and Bulb to Fixture Body
Nipple
E
x 1
A. Pass Lock Washer (D), Fixture
Hood and Water Proof Washer
(B) over the Nipple (E), secure
by threading Finial (B) onto
Nipple (E). Hand tighten until
sung.
B. Insert bulb and screw snugly into
place.
C. Place Shade (G) into Fixture
Body (F) properly. Then Place
the Fixture Hood onto the top
edge of the Fixture Body (F) and
secure with Lock Screws.
Tighten until snug.
STEP 3 - Mark the Location for the 3 Mounting Holes
A. Place the light fixture onto the post and mark the location of the 3
mounting holes on the fixture fitter onto the post with the marking
pen.
Fixture
Fitter
Post
1of2
_R1
C
D
Figure 2
Post
Lighting
Marking Pen
Mounting
Hole
Figure 4
RevisedDate:2017-10-25
B
Lock
Screw
Fixture
Hood
E
G
Vintage Bulb
(recommended
but not supplied)
F
Fixture
Fitter
Post