Ventura Bike-Pack System SR18B Instructions And Warranty

Thank you for purchasing our VENTURA BIKE-PACK SYSTEM.
Before use please read all instructions and our Limited Warranty carefully.
To Fit : Kawasaki Ninja 650R
(12-14)
K103/B L-Brackets
PF18/B Pack-Rack
SR18/B Sport-Rack
GH12/18/B Grab-Handle
A range of various style packs for the Aerodynamic
systems, along with storm covers and optional shoulder
straps (where applicable) are available.
Check with your local dealer, distributor or contact us direct
for the latest models.
FITTING KIT CONTENTS
LD001/B locking device (fitted to L-Brackets)
1 x LK001/S Key
2 x M8 x 80 allenhead capscrews (bright zp)
4 x M8 x 14 x 1.0 flat washers (bright zp)
2 x M6 x 65 set screws (bright zp)
2 x M6 x 20 set screws (bright zp)
6 x M6 x 12.5 x 1.2 flat washers (bright zp)
2 x M6 nyloc nuts (bright zp)
2 x Part #469 stepped washers (bright zp)
1 x K103 crossmember
RECOMMENDATION: When carrying a single pack always
face it forwards with the weight over the pillion seat. When
two packs are used, the largest capacity pack must be
carried facing forwards with the weight over the pillion seat.
WARNING: When using a pack facing rearwards it must be
supported by the carrier portion of the pack rack. The carrier
of the pack rack must be fitted facing the rear. Failure to
comply can result in irreparable damage to the pack or its
contents.
HELPFUL HINT: To ease fitment into the L-Brackets we
recommend a light coating of beeswax, candle wax or light
grease be applied to the bottom of the Pack-Rack legs.
WARNING: Read your owners manual, do not exceed the
manufacturers maximum recommended weight for rider,
pillion and luggage combined.
K103B : Issue 3 : May 2014
Manufactured by:
ER-6N
(EX650ECF),
NOTE: On 2014 models the mudguard extension panel shown in
Diagram #1 will need to be removed and discarded to enable
fitment of the K103 crossmember.
Diagram #1
Legend to Diagram #1
128-134 Maui Street, P.O. Box 10-393, Hamilton, New Zealand
Telephone +64 (7) 849 4392, Facsimile +64(7) 849 4114
E-mail: dold@ventura-bike.com Internet: www.ventura-bike.com
FITTING INSTRUCTIONS
(1) Remove and discard this panel
1. Remove the seats and tool kit.
2. Remove and discard the two M6 rear subframe to rear
indicator / number plate support bolts from inside the
rear compartment.
3. Using the M6 x 65 set screws supplied, fit the K103
crossmember as in Diagram #2 with M6 x 12.5 x 1.2
flat washers provided between the crossmember
mounting tubes and the bike. Leave loose.
Page 1 of 4