Advertisement
Quick Links
CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:
Recommended Supply Pressure:
Maximum Flow Rate:
Operating pressures between hot and cold supplies should vary no more than 30 psi.
*
If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (PRV).
†
1
INSTALLING SPOUT TO SINK/DECK
Tighten spout BASE (4) and DECORATIVE NUT
(2) onto spout RISER (3), and slide onto spout
SHANK (1a)
Insert spout SHANK (1a) though sink/deck hole
NOTE: Sink/Deck recommended hole size shall be Ø1-3/8"
From underside, place SLOTTED WASHER (5)
onto spout SHANK (1a) and tighten SPOUT (1)
into place with NUT (6)
Insert RUBBER WASHER (7) into TEE (8) and
attach to spout SHANK (1a)
IMPORTANT: TEE (8) should be tightened to create watertight
seal and positioned to allow ease of attachment of valve hoses
CF-8502_ii_190102
Steampunk Bay
CF-8502 & CF-8602
Widespread Lavatory Faucet
Installation Instructions
BY A LICENSED PROFESSIONAL
*†
20 to 70 psi
1.2 gpm
™
1a
5
6
7
8
1
1a
2
3
4
Ø1 3/8
- "
Pg 1
Advertisement
Summary of Contents for California Faucets Steampunk Bay CF-8502
- Page 1 Steampunk Bay ™ CF-8502 & CF-8602 Widespread Lavatory Faucet Installation Instructions CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED BY A LICENSED PROFESSIONAL IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer. Operating Specifications: *†...
- Page 2 INSTALLING VALVE From underneath insert VALVE (12) though appropriate sink/deck hole IMPORTANT: VALVES (12) are labeled as follows: BLUE COLD left turning (counter-clockwise) closed right-turning (clockwise) closed 1-1/2" Position flange NUT (10), WASHER (9), and SPACER (11) so that VALVE (12) extends 1-1/2” above sink/deck surface ...
- Page 3 INSTALLING HANDLE Slide HANDLE (15) down onto and engage valve STEM (12a) Tighten handle NUT (15b) INSTALLING VALVE HOSES Attach small hose NUT (16a) to spout TEE (8a) Attach large hose NUT (16b) to valve side OUTLET (12b) ...
- Page 4 INSTALLING DRAIN Slide white foam WASHER (17) up under flange of BODY (18) - or - ® Apply thin film of Silicon sealant (or equivalent – DO NOT use petroleum-based sealant as this WILL void finish warranty) to underside of flange on BODY (18) ...