Page 1
Support bar Removable top grate Media bag Dual Bio-Tech filter mats Solid lip and molded-in inserts Bottom grate One-piece liner attachment flange 1-1/2” heavy-duty bulkhead Sturdy Oasis BF1600 Features Parts List Oasis PS3900 Features Parts List removable lid Matala ® Spillway Bottom Grate Weir Width...
Page 2
Water Gardens 3’3” 10’ 8’ 5’ LENGTH WIDTH DEPTH CLASSIC 2-SKIMMERS 2-FILTERFALLS Oasis Skimmer Installation EXCAVATING AND SETTING THE SKIMMER (PS3900) Prior to setting the skimmer you must first determine the surface level of the water in the pond. Once you have this number you can excavate for the Skimmer.
When you are finished, remove the spring clips and pull the liner away from the face of the skimmer. Apply Atlantic’s fish-safe silicone around the weir door opening on all four sides. Apply a consistent bead of Atlantic fish-safe silicone to the face of the Skimmer along the centerline of the pre-drilled bolt holes.
Page 4
Make sure that the front of the FilterFalls and the back side of the liner are clean It is always recommended that the FilterFalls be placed on undisturbed and free of debris. Apply a consistent bead of Atlantic fish-safe silicone to the soil if possible. If the installation calls for the FilterFalls to be elevated above face of the FilterFalls along the center line of the threaded inserts (fig.
Page 5
Locate the correct reference mark for this installation on the discharge pipe. Using a hacksaw or PVC saw, cut the pipe at this mark being careful to make a clean, square cut. Discard the end of the discharge pipe that will not be used. fig.
Page 6
SKIMMER OVERFLOW A drill-point has been provided on the back of the Oasis skimmer to show the proper location and elevation to install an Atlantic HA2000 bulkhead fitting for the overflow (not included). See diagram above for drill-point location. This combination will position the bottom of the overflow pipe approximately 1”...