Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
GRIPPER CONNECTOR
LLI-GC-LL-RGB
LLI-GC-LW-RGB
LLI-GC-LL-RGBW (
)
12mm only
LLI-GC-LW-RGBW (
)
12mm only
LLI-GC-LL-SC
LLI-GC-LW-SC
**DANGER: Prior to installation, disconnect power at the source.**
Make sure you have all components listed below:
• LED tape
• Gripper connectors
• 18-22 AWG wire (if using wire connectors)
Page 1
847-412-4880 // info@llialighting.com // 1555 Barclay Blvd. Buffalo Grove, IL 60089
Advertisement
Summary of Contents for LLI LLI-GC-LL-RGB
- Page 1 INSTALLATION INSTRUCTIONS GRIPPER CONNECTOR LLI-GC-LL-RGB LLI-GC-LW-RGB LLI-GC-LL-RGBW ( 12mm only LLI-GC-LW-RGBW ( 12mm only LLI-GC-LL-SC LLI-GC-LW-SC **DANGER: Prior to installation, disconnect power at the source.** Make sure you have all components listed below: • LED tape • Gripper connectors • 18-22 AWG wire (if using wire connectors) Page 1 847-412-4880 // info@llialighting.com // 1555 Barclay Blvd.
-
Page 2: Installation Instructions
INSTALLATION INSTRUCTIONS GRIPPER CONNECTORS Please read all steps before beginning the installation. • These products may represent a potential shock or fire hazard if improperly installed or attached in any way. Products should be installed in accordance with these instructions, local electrical codes and the National Electric Code (NEC). -
Page 3: Prior To Installation
INSTALLATION INSTRUCTIONS GRIPPER CONNECTORS Prior to Installation NOTE: Ensure the LED strip fits into the connector. Check to make sure the number/location of pins on connector match the number/location of solder pads on the LED strip. NOTE: Can be used with dry location and resin dipped LED strip types. Do not use connectors with solid silicone and silicone covered LED strip types. - Page 4 INSTALLATION INSTRUCTIONS GRIPPER CONNECTORS Attaching LED Strip to Connector STEP 1 STEP 2 Open cap of connector exposing LED strip Insert LED strip into connector until fully light connection pins. seated against the back of the connector block. STEP 3 Click Press connector cap down to lock in place.
- Page 5 INSTALLATION INSTRUCTIONS GRIPPER CONNECTORS Attaching Wire to Connector NOTE: It is not necessary to strip wires. STEP 4 STEP 5 Open cap of connector and expose the wire Insert the wires into connector until fully seated blades. against the back of the connector block. Ensure the wire polarity matches that of the LED strip.
- Page 6 INSTALLATION INSTRUCTIONS GRIPPER CONNECTORS Low Voltage Wire Gauge Chart 24V DC Voltage Drop and Wire Length (ft.) Distance Chart Power (W) 100W 110W 120W 189’ 94’ 63’ 47’ 38’ 31’ 27’ 24’ 21’ 19’ 17’ 16’ 300’ 149’ 100’ 76’ 60’...