Knape&Vogt MUV+ Series Manual

SPECIFICATIONS
Number:
Full Extension Soft-Close Undermount Drawer Slide
Mounting:
Side, for Frame or Frameless Construction
Height:
1-7/8"
Load Rating:
75-Pound Class
Finish: Zinc
Travel:
Full Extension 14"–22", Partial 9"–12"
Sizes:
9", 10", 12", 14", 15", 16", 18", 20", 21", 22"
Packaged:
Bulk (B): 6 Pairs per Carton. Lengths 14"-22".
Bulk (B): 4 Pairs per Carton. Lengths 9"-12".
Release Lever:
MUV1D-RL: Up/Down Height Adjustment. 60 pairs per carton
MUV2D-RL: Up/Down Height, Side-to-Side Adjustment. 24 pairs per carton
MUV3D-RL: Up/Down Height, Side-to-Side, In/Out Adjustment. 12 pairs per carton
MUVRL INSET: Inset Adjuster (MUV2D-RL Add On). 12 pairs per carton
Rear Brackets:
MUV-RBM: Metal Rear Bracket (for use on 14", 15", 16", 18", 20", 21", 22" Slides). 12 Brackets (Unhanded)
MUV-RBP: Plastic Rear Brackets (for use with 9", 10", 12" Slides). 8 Brackets (4 Right Hand, 4 Left Hand)
Fasteners:
MUV-122: #7 x 5/8" Flat Head Screw – Slide
MUV-123: #6 x 1/2" Truss Head Screw – Front Release Levers and Rear Bracket
Install Jig:
MUV-124
15/16"
[24mm]
Drawer Bottom
Full Extension Soft-Close
Undermount Drawer Slide
DRAWER ASSEMBLY
DRAWER HARDWARE INSTALLATION
1-1/4"
[32mm]
Variable
1/4" [6.3mm]
Optimal Operation Guidelines for Drawer Width Based on Drawer Height:
Drawer Height up to 6":
Drawer Height Greater than 6":
Drawer Hight Greater than 8":
Drawer Height Greater than 10":
Reference Page 6 for two critical drawer dimensions:
• Max. Drawer Bottom Recess
• Inside Drawer Width
Release Lever Adjustment (1/8")
(Vertical Adjustment)
1
Material Thickness
For use with the following
material thicknesses:
5/8" [16mm]
9/16" [14mm]
1/2" [13mm]
Max. Width = Slide Length + 10"
Max. Width = Slide Length + 10"
or 28", whichever is less
Max. Width = Slide Length + 10"
or 24", whichever is less
Max. Width = Slide Length + 10"
or 21", whichever is less
Pre-drill front holes
at 15º angle.
Drawer Bottom