• Installation must be performed only by a properly trained
operator or an electrician.
• Applicable electrical installation rules must be followed.
• The unit must be used only as a surge protector and according
to the conditions described in this document.
Technical Data
1251-
Specification
120S-
N1
•
Single Phase
Split Phase
Wye
Type
Max. Discharge
Current by Mode
(Imax)
Nom. Discharge
Current by Mode
(In)
MCOV L-N
(Vac)
MCOV L-L
N/A
(Vac)
NOTES:
Model 1252 Series contains a filter.
N1: For the side nipple.
N2: For the nipple in the back.
The device characteristics and parameters in this data sheet can and do vary in different applications and actual device performance may vary over time.
Page 1
N1: For the side nipple. N2: For the nipple in the back. Asia-Pacific: Tel: +886-2 2562-4117 • Email: asiacus@bourns.com EMEA: Tel: +36 88 520 390 • Email: eurocus@bourns.com The Americas: Tel: +1-951 781-5500 • Email: americus@bourns.com www.bourns.com Specifications are subject to change without notice.
Page 2
1251 & 1252 Series Hardwired AC Hybrid H-SPD INSTALLATION INSTRUCTIONS Installation 1. Disconnect breaker supplying all power to the equipment Figure 1 prior to SPD installation. 2. See Figure 1. Main switchboard or sub-panel 3. Confirm Model 125x Series device is rated for your system by comparing voltage measurements to the Line Voltage on the product label.
This manual is also suitable for:
1252 series1251-120s-n11251-208y-n11251-120s-n21251-240s-n21251-240s-n1...
Show all