Parker Research Corp PL-10 Manual

Parker's portable magnetizing
coils are designed for
magnetic particle inspection of
ferrous metal parts. The coils
allow for the use of either dry
powder or wet fluorescent
inspection media and may be
used for demagnetizing as
well.
The coils are molded in a
tough, black polyurethane and
comes equipped with a foot
switch and 10' (3.048 m)
neoprene power cord. The
sealed electrical connection
box has a 2" (50.8 mm) x 5"
(127.00 mm) flat base allowing
the coil to stand in a vertical
position.
The PL-8, PL-10, PL-8PDC, and PL-10PDC operate from a standard 115VAC, 60 Hz single
phase grounded power source.
The PL-8S and PL-10S are for use on 230VAC 50-60 Hz single phase grounded power
source. The PL-8S and PL-10S are sold without power cord plugs. Only locally approved
plugs should be used and installed by certified personnel. Using an approved GFCI is
recommended.
Model No. PL-10
9 7/8"
Inside Dia.
14 ½"
Outside Dia.
2 ½"
Width
115VAC
Line Voltage
225
Turns
Frequency 60 Hz
Line Current (air) 13.4
Amp-Turn (air) 3015
14 7/8 lbs.
Weight
PORTABLE MAGNETIZING COILS
PL-8
Specifications
PL-10PDC
PL-10S
9 7/8" 9 7/8"
14 ½" 14 ½"
2 ½" 2 ½"
230 VAC 115VAC
425 425
50 Hz 60 Hz 60 Hz
9.6 7.8 5A
4080 3315 2125
13 7/8 lbs.
14 7/8 lbs.
BULLETIN 277
MARCH 2014
PL-8 PL-8S
8" 8"
11 ½" 11 ½"
2 ¼" 2 ¼"
115VAC 230 VAC
271 520
60 Hz 50 Hz 60 Hz
12 8.1
3252 4212
9 7/16 lbs. 9 7/16 lbs.
PL-10
PL-8PDC
8"
11 ½"
2 ¼"
115VAC
520
60 Hz
4A
6.8
2080
3536
8 7/16 lbs.