CableWorld CW-4000 Series Operating Instructions

PROFESIONAL DIGITAL TELEVISION EQUIPMENT
CW-4881 TS GENERATOR & INSERTER
Dear User!
Digital television technology permits implementing
numerous features, which could not or hardly could
be achieved in analogue technology.
The CW-4881 Transport Stream Generator
Inserter has been designed for creative technicians,
who want to realize their ideas also in television
technique.
The device comprises two flash memories. One of
them is always in operation state, and the other can be
programmed from the user's PC.
1. MECHANICAL CONSTRUCTION
The CW-4881 Transport Stream Generator & Inserter
is built in standard 19" × 1 HU instrument frame. It is
delivered along with following accessories:
1. Power cord
2. Spare fuse T 1.25 A
(placed in the fuse holder mounting)
3. Crossover cable with RJ45 connectors 1 ea.
The power consumption of the device is very low
therefore no cooling or ventilation is needed, however
do not use it covered, blocking the natural airflow.
07/07
KÁBEL-TV RENDSZEREKET GYÁRTÓ ÉS FORGALMAZÓ MAGYAR - AMERIKAI KFT.
A HUNGARIAN - AMERICAN LTD. COMPANY FOR MANUFACTURE AND SALES OF CABLE TV EQUIPMENT
CW-4000
&
1 ea.
1 ea.
OPERATING INSTRUCTIONS
2. ELECTRICAL CONSTRUCTION
A CW-4881 Transport Stream Generator & Inserter is
a device of simple structure but very wide scope of
application.
The device is equipped with an own switching
mode power supply. The supply voltage of the
interface circuitries is 3.3 V; the signal processing
circuitries are supplied with a voltage as low as +1.2
V. The power consumption is low; the device is
suitable for continuous service.
Programming of the device is made through
CableWorld's CW-Net system; the steps of putting in
operation the system
Using_CW_Net.pdf file at www.cableworld.eu.
All items of CableWorld software are available for
free download and use at www.cableworld.eu. The
software user manuals are available in the Help
menus and also on the web site, separately in pdf
format. The CW-4881 Transport Stream Generator &
Inserter can operate with all CableWorld software.
All CW-Net controlled CableWorld devices are
shipped with the IP address set to 10.123.13.101.
Prior to using them in network, the IP address must
be changed to avoid conflict between the IP
addresses.
For changing the IP address download, install and
use the SW-4800 software. All knowledge necessary
for this is included in the Help file of the software.
is described in the